Search results

  1. R

    Suggestions rebuilding a Bowrider

    You are looking to build a bow like in the pictures for your own boat?
  2. R

    1956 Fastwin 15 Drive Shaft and Impeller Issues

    The pin at the top of the driveshaft rotates / drives the seal assembly.
  3. R

    1956 Fastwin 15 Drive Shaft and Impeller Issues

    ????----On the 5.5 HP there is a hole for a pin / key to drive the impeller !------Not possible to install driveshaft upside down on a 56 model 15 HP.
  4. R

    Confused New Owner of an Old Boat

    Looks like it had water in it and froze.------Gear housing needs to be replaced.
  5. R

    Confused New Owner of an Old Boat

    That is correct.----A GM inline 6 model.------Many ( not all ) had issues with structure under the floor.----Boat appears to have been looked after.
  6. R

    Info on Evinrude 115 E115TLETS

    Start another --" oil thread "----On the fundamental difference between TCW oils and oil meant for direct injection engines ?
  7. R

    Info on Evinrude 115 E115TLETS

    I see post #17----I am not sure why the comment about---" Absolutely makes an injector oil " ----is even in that post.-----I am just curious as to what is meant by that comment
  8. R

    Oil coming out of carburetor

    See post #10
  9. R

    Info on Evinrude 115 E115TLETS

    Not sure why this was mentioned in post #17.----The statement does not make sense to me.
  10. R

    Oil coming out of carburetor

    How did this motor run for you last season?
  11. R

    Oil coming out of carburetor

    One way for gas to get in the oil is via a defective fuel pump.----Oh --these 4 strokes with all their hidden issues.
  12. R

    Oil coming out of carburetor

    Was the motor stored properly?---Laid down in wrong side perhaps ?
  13. R

    1956 Fastwin 15 Drive Shaft and Impeller Issues

    Pull lower unit apart.----Some pinion gears use a circlip to position the driveshaft.----Clip might be missing / broken or rusted away.
  14. R

    Confused New Owner of an Old Boat

    Post pictures of the damaged / cracked housing.----Only way to get accurate opinions on repairs.
  15. R

    Evinrude Tilt Trim motor

    Is the drive coupling in place ?-----Does your system use a 2 wire ( green and blue ) or 3 wire ( green , blue and black ) on the motor ?----Is manual release valve tight ?
  16. R

    bravo III milky oil but holds pressure for days

    Install a seal kit now.-----Cheaper than gears and bearings.----Seals wear out and could be half worn now.
  17. R

    Mariner Idle Stabilizer - Spark Advanced Module

    Most folks would say to remove the idle stabilizer and throw it away as far as you can.
  18. R

    Possible water intrusion or lean sneeze?

    Off topic-----There is no head gasket on this Mercury motor.
  19. R

    Info on Evinrude 115 E115TLETS

    "Absolutely makes an injector oil "-----Explain what that means.
  20. R

    1978 700 series 70hp mercury high idle

    Motor slows down with choke because it is flooding.----I do not believe this is a fuel issue.----In my opinion it is a timing issue.
Top