Search results

  1. B

    1998 Mercury 150EFI wiring help

    It will be found in the applicable Mercury service manual.
  2. B

    Suzuki DT115 Voltage Regulator/ Rectifier

    I presume that you have but two electrical leads coming from the stator coil. Is that correct?
  3. B

    1999 F40TLRX DIAGNOSTIC PORT LOCATION

    A 1999 F40TLRX does not have YDIS capability.
  4. B

    1995 Yamaha 130 oil injection lroblem

    Black to the switch. Black/red from the switch. From the blue connector. Notice that at a junction point with the engine harness the B/R turns to green/black. G/B to the oil control module and G/B to the oil connector (#25). The switch referred to is within the sensor switch assembly located...
  5. B

    yamaha 250 electrical steering

    A complete model identity will help.
  6. B

    35 HP - Never had Charging even though it's electric Start? Is this possible??

    Go to the Mercury Marine parts catalog https://www.mercurymarine.com/en/us/parts-and-accessories/parts-catalog?gclid=CjwKCAjwpKveBRAwEiwAo4Pqm6JIrzner3CFcr-0DidW_n0WQYnRdOVfmu02gJDFF3ONGayJbxAydhoCahcQAvD_BwE and enter the serial number into the search box. It will take you to where you have...
  7. B

    1995 Yamaha 130 oil injection lroblem

    The yellow light is telling you that the remote tank in the boat is low on oil. Or the oil control unit thinks that it is low. When there is sufficient oil in the tank a sensor switch closes due to a float in the tank rising. In which case a ground goes from through the switch and on to the oil...
  8. B

    F150 Engine Alarm/Buzzer

    No to the wiring being installed. With a Yamaha temperature gauge and temperature sender the sender has the wire attached to run to the Yamaha gauge. I have no idea what the Faria temperature gauge and sender consist of. Yamaha does not offer either a mechanical or an electrical oil pressure...
  9. B

    F150 Engine Alarm/Buzzer

    You will need to craft a T fitting so as to get oil pressure to an oil pressure sender.
  10. B

    2003 Yamaha Outboard oil injection adjustment

    What's a service manual?
  11. B

    Mariner 40ELO 6E9-451908 blows fuse after starting

    There are numerous connection points within the circuit from the lighting coil to the rectifier and on to the battery. Or from the battery through the fuse and on the start switch. Presumption being that your motor is wired similar to its Yamaha equivalent. Start by disconnecting wires as...
  12. B

    2003 Yamaha Outboard oil injection adjustment

    Have you any idea as to the model of the motor? Is it a 25TLR, a Z300, or something in between?
  13. B

    Mariner 40ELO 6E9-451908 blows fuse after starting

    So you do or do not have a Yamaha manual for the motor? Manual by Yamaha. Not some aftermarket stuff.
  14. B

    Mariner 40ELO 6E9-451908 blows fuse after starting

    Look at the main wire harness up near the connector at the front of the motor. Is there a label with the part number on it?
Top