Search results

  1. flyingscott

    Reed/Leaf Valves

    No reed valves will not cause that. What motor do you have.
  2. flyingscott

    1988 Stratos 189v with Evinrude Xp 200 Fuel pump not getting power.

    If you have an actual electric fuel pump get rid of it. They are nothing but problems. Find the correct mechanical pump from a 1980 V6 and use that.
  3. flyingscott

    1988 Stratos 189v with Evinrude Xp 200 Fuel pump not getting power.

    You should not have an electric fuel pump on that motor. The wires off the VRO pump are for a sensor not the pump itself. Check compression and spark.
  4. flyingscott

    why won't the flywheel turn over manually

    Take the lower unit off and see if it turns.
  5. flyingscott

    2003 Mercury 200 2 Stroke carb running hot at idle. New impeller, new thermostats

    That motor has the tell tale connected directly to the thermostat. pretty specific to the 2.5 merc motors also done on the smaller 25 hp motors. I think you are looking for problems that are not there.
  6. flyingscott

    new to me 1970 Johnson 25hp tiller short shaft. locked up

    I do not know how you are getting a 2026 delivery on an NLA piston. A little more looking on your part. I can't put the website up because it is a competitor. they say 10+ in stock have found them to be quite on top of their inventory.
  7. flyingscott

    2003 Mercury 200 2 Stroke carb running hot at idle. New impeller, new thermostats

    Why not? The thermostat only opens at 143 deg not abnormal for a motor to run hotter than that.
  8. flyingscott

    1966 Johnson 6hp magneto timing issues

    Spark plug wires on the wrong plug?
  9. flyingscott

    2020 Yamaha 115 vmax cooling issue

    Is this motor under warranty? It's only 2 yrs old.
  10. flyingscott

    What size prop for my 200 EFI merc

    Something is drastically wrong there. I would start by looking at the EFI conversion.
  11. flyingscott

    Suzuki 75hp

    Yamaha and Suzuki both did that. Best oil injection system put on carbed 2 strks.
  12. flyingscott

    Rec gas prices???

    No matter what the measurement is, a screwing is a screwing no matter what country you live in.
  13. flyingscott

    Glastron GT-150 Ideal Prop for Slalom Skiing

    Are you dropping a ski or getting up on one? I had one of those with an 85 Evinrude on it and 48-50 was my top speed. It would also be my last choice for a ski boat.
  14. flyingscott

    rewiring a power trim tilt

    It only uses 1 solenoid, it looks like a starter solenoid.
  15. flyingscott

    FLASHING A 60 HP SCOTT GENERATOR

    Then you should be good to go. I won't be home for another week. So you can find a video or I will upload parts of the manual later. It is not that hard to do.
  16. flyingscott

    FLASHING A 60 HP SCOTT GENERATOR

    It's been forever since I have done it. But I do have the service manual for those motors. Is the Voltage regulator in good shape? What you are doing is polarizing it. Make sure your points are set before you do it. This video is the one I have bookmarked to do it.
  17. flyingscott

    new to me 1970 Johnson 25hp tiller short shaft. locked up

    qwik google search showed a place with 10+ standard pistons in stock
  18. flyingscott

    Wire location ?

    That is a ground wire put it on one of the mounting screws. Between the block and the switchboard. Clean that surface to shiny clean. I can't ever stress enough get a factory manual and do the tests.
  19. flyingscott

    4Cyl 2Strk lower cylinder won’t fire. Has spark but low compression.

    The sensor is in the tank. Do you have the tach with 3 lights? And yes that 100#s of compression is concerning. But that motor should have had 2 tanks I believe. You might need to buy a factor manual for your motor.
  20. flyingscott

    4Cyl 2Strk lower cylinder won’t fire. Has spark but low compression.

    Look for wires rubbing somewhere? What year Yamaha 115? Are all the linkages moving smoothly? Anything broke? Bad oil sensor?
View older results
Top