Search results

  1. S

    1972 johnson 75hp lift assist issue

    According to my chart 1975 is the earliest they made a 75 hp. They show a shock abs and spring for the 20 inch model but different part number than you list. 2 per unit. Should help going down not sure on the up. They do sell an aftermarket lever that you put on the engine cover to help lift it...
  2. S

    1986 6 hp Johnson Gearcase Cover and Seal

    I assume you are installing gasket 324637 keeping the gearcase sealed on the top. No sealer should be required but I don't think it hurts either. Let's see what others say. As long as you have that part out did you replace the other seals?
  3. S

    Starter Bolt Size

    All three should be the same. 1/2 bolts, not sure of the thread though. Looking at your motor with all the Allen heads and stuff maybe someone had to tap that out.
  4. S

    50hp electric start evinrude reverse issues

    I did not know that. Thanks
  5. S

    50hp electric start evinrude reverse issues

    The c and the i represents 1981. Engines don't have titles, are you looking at your boat title?
  6. S

    1974 evinrude 135hp starting and staying on problems

    Well you kind of rambled there a little bit but I will attempt. Motor was stored along time, started with starting fluid..... My guess is you need to go through the carbs. Most will say do not use starting fluid you could burn it up.
  7. S

    Yamaha 225hp ox66 tilt and trim help

    I know that happens to me too, I'll read a couple of threads and then cross them up. Age thing I think!!
  8. S

    Is this normal for water to come out these 2 holes?

    Exhaust vents out the prop unless it has to much back pressure and then it vents out the holes. Can't tell your water level is but make sure it's up far enough....(above the pump aways)
  9. S

    Yamaha 225hp ox66 tilt and trim help

    Not sure what 99 is saying because you made no reference to the relay clicking. Here is where some Yamahas hide the fuse. Port side front in a box.
  10. S

    Yamaha 225hp ox66 tilt and trim help

    Did some more digging and it is fused. The red wire going to your relay should be hot without the switch being used so if it's not you have no power for some reasons. Still betting fuse. Here is a way to test you relay next time.
  11. S

    Suzuki DF115 transom (Trim/Tilt) saver??

    Agreed
  12. S

    Yamaha 225hp ox66 tilt and trim help

    Okay, not sure how to splice in but I think I have an idea. Normal things to think of are bad ground, electric motor or fuse. Because you made it run my bet you have a bad fuse somewhere. They love to hide those things so search all around the motor for some kind of fuse holder.
  13. S

    1986 4 hp Evinrude poor idle

    1st of all, I had a First of all I had a 4hp Deluxe and it had much higher compression than yours. It was used so I can't speak about what it had when new. I have also ran compression checks on many small motors that were much higher than you say. Not sure piston size means anything. Most...
  14. S

    Suzuki DF115 transom (Trim/Tilt) saver??

    Never said it was. The conversation started out that his new 2022 Suzuki didn't have anything for trailering. Then the conversation went from there. Re-read the thing and then it will make sense.
  15. S

    8MLHU limited RPM

    Agree with above. And if your using it in a test tank and trying to go WOT then that's not good. You would need a dyno.
  16. S

    Suzuki DF115 transom (Trim/Tilt) saver??

    It's a 115 Gen 1 Etec. Here is your pictures.
  17. S

    1986 4 hp Evinrude poor idle

    100 psi is not what I would call great. Usually, coughing and sneezing is a result of carburetion. Sorry, I can answer the other questions.
  18. S

    Are there only 2 grease ports on my outboard

    There should be two on the transom bracket to tilt tube. (Might be what your calling steering rod) Then there should be one on the side that greases where the motor swivels whole steering. Grease comes out the top and bottom of the midway section of the engine.
  19. S

    35 Johnson overheating

    Pricey but available.
  20. S

    Suzuki DF115 transom (Trim/Tilt) saver??

    My motor has two different things. One is a single cam for working on or to be used when mooring and a heavy duty double arm thing to be used for trailering.
Top