Search results

  1. Scott06

    Converting to carburetor from mpi 350 mag

    Knock sensor will not be used with DUI or Delco set up. buy a Delco or DUI complete setup and that is all you will need
  2. Scott06

    Converting to carburetor from mpi 350 mag

    actually the opposite. Normally you can get the delco est complete system a lot less than the TBV module.
  3. Scott06

    Converting to carburetor from mpi 350 mag

    Davis unified ignition or the several times previously mentioned Delco est are two stand alone ignition systems that will work fine for your Application. Delco is more common in marine applications and used on some Volvos and mercruisers as OEM The distributor sensor sends a signal to the...
  4. Scott06

    Replacing 5.0 oil pan, gasket, bolts

    Front timing cover is plastic some have a crank trigger sensor that are one time use. If you can find GM parts they are OEM with one less (merc mark-up)
  5. Scott06

    Engine dies going into reverse

    If annodes are depleted yes. Transom kit is https://nuwavemarine.com/mercruiser-transom-assembly/alpha-gen-2-transom-assembly-parts/alpha-gen-2-bellows-repair/oem-mercruiser-alpha-1-gen-2-transom-bellows-repair-reseal-kit-30-803099t1/ includes bellow gimbal bearing water and oil hoses. etc...
  6. Scott06

    Converting to carburetor from mpi 350 mag

    on a TB five its on the exhaust elbow opposite shift interrupt bracket or back of distributor not shift interrupt.
  7. Scott06

    Converting to carburetor from mpi 350 mag

    So if you dont have a TB ignition module because it was in the ecm the t bolt will not work. As suggested early on in this thread u will need to get two delco est setups to make this work, as even if you could rig up a TB module you will pay more for the modules than a complete delco est set up,
  8. Scott06

    Converting to carburetor from mpi 350 mag

    Goes between ignition module and dist on tb ignitions not dist and coil whats your engine number
  9. Scott06

    Maxum SR 1800 wandering at low speed

    I had same experience- my old '91 Sea Ray 170 had none of it, my 2004 Sea ray 200 sport has brutal wander.
  10. Scott06

    Engine dies going into reverse

    If it hasn't been done it is a good time to go through the transom - all 3 bellows /shift cable/ trim switch and sender... use OEM merc parts and they will last just as long.
  11. Scott06

    Engine dies going into reverse

    I had a torn exhaust bellow for two seasons, but driveshaft bellow only had some light fraying on the OD of it where it rubs the gimbal ring/hinge pins... I think the bellow gets hard as time goes on and rubs vs flexes. Shift bellows was ok... says something about OEM bellows.
  12. Scott06

    Maxum SR 1800 wandering at low speed

    typical v hull wander, biggest thing is to resist the urge to over correct. I'm sure other hulls may be different but if you put very small corrections in the steering wheel you can basically work around it. Of course it took me a couple seasons to figure that out...
  13. Scott06

    Bravo 3 loud knocking/ticking Sound Video

    Post 1 said does it in fwd neutral and rev.
  14. Scott06

    Thunderbolt 5.0 keeps dying

    float adjustment but doesn't include specs... https://www.carburetor-blog.com/knowledge-base/mercarb-float-adjustment/ Mikes has some good videos of this as well
  15. Scott06

    Engine dies going into reverse

    I have the same- 2004 boat , 370 hours on original gimbal, Ujoints, and shift cable. Did bellows last spring before they started leaking cable is smooth as silk..
  16. Scott06

    Constant alarm on Merc 3.0

    Best to start your own thread specific t your issue as they frown upon people posting on old threads. I'm sure a mod will be along shortly to close the thread
  17. Scott06

    Gimbal Bearing Science

    Yes absolutely grease it while idling In the old days you could just flip the bearing 90 degrees in the outer carrier to replace but merc started installing them the other way around to prevent this
  18. Scott06

    sudden loss of power

    Take the fuel filter off and dump contents in a clear container. if there is junk in there you will need to clean whole fuel system. if ok put the filter back on.
  19. Scott06

    Lower unit lifter. Solenoid?

    Usually if you have to use the trailer button to raise the drive the trim limit switch is bad. It is on the port side of gimbal ring and can be jumpered in engine compartment or at trim pump. Can't comment on transom switch but both throttle and transom switches will activate the same two...
  20. Scott06

    142 supercharger on a stock 5.7 ?

    Yes on the AFR meter./O2 sensor stab in. I have moved the same meter between my 65 GTO and my boat. would not do this without it Will provide much better info than plug reading, especially in transition areas like rich/lean step up on rods, secondary kick in Etc
Top