Search results

  1. jimmbo

    I thought towing doubles was legal in some states? 😁

    And some people still refuse to add a Chain, or Rope to fasten the Bow Eye to the Winch Stand, or use Straps to secure the Stern... I wonder if Henry and Harold Handcuff, ticketed the Guy for driving with Undue Care and Attention?
  2. jimmbo

    Help with my outboard!

    I was referring to priming the Water Pump, it needs to be submerged, as it is several inches above the water inlets
  3. jimmbo

    Help with my outboard!

    Some 25 hp mariners had Head Gaskets
  4. jimmbo

    1990s Mercury 90 HP Lower unit mounting nuts

    I found the nuts that hold the gearcase on to be part #11-40140 M10x1.5 threads
  5. jimmbo

    Help with my outboard!

    You need to have the water several inches above the Pump housing, to insure it is Primed. Ona lot of Outboards the Pisser isn't discharging water that made it through the Block, just water that has made it to the Block. As the Exhaust and water do mix in the Exhaust tube, some exhaust may find...
  6. jimmbo

    Upgrading from 70hp to 90hp

    A 20 hp increase will get you about 4 mph more top end. I guess there is a Chance that for one Year they made the boat differently and thus the reduced HP Limit. Myself, I have never worried about a slight Overpower. I always made sure the Underwriters of the Insurance, knew it was exceeding...
  7. jimmbo

    Boat not planing

    I have never seen a boat refuse to plane because of a 25 liter Portable tank being added to the Bow area, in most cases it improved the ability to get on Plane. The added weight of the Kicker is about the weight of 2 full 25 liter tanks Are you trying to plane the boat with the Kicker up or down?
  8. jimmbo

    2000 70hp Johnson semi start/ won’t stay running

    When I said specific, I meant a Genuine OMC/BRP Service manual
  9. jimmbo

    2000 70hp Johnson semi start/ won’t stay running

    You need to get a Service Manual specific to that Model/Year of Motor
  10. jimmbo

    2000 70hp Johnson semi start/ won’t stay running

    After you remounted the carbs did you check/verify the Sync between the Carbs and Spark Timing? Also, how did you set the Idle speed? What Rpm is the Engine Idling at in gear, in the water? When you checked the spark, did you verify that it could jump a 3/8" gap on all cylinders?
  11. jimmbo

    97 Force 120- Low idle at times, stalls when engaging into gear

    What Rpm is the engine running at Idle, when in Gear? Maybe all it needs is a slight adjustment of the idle speed stop, though that is a bit more complicated than just turning a screw as it usually also requires adjusting the Throttle Cable length, so check out the things racer said above
  12. jimmbo

    No oil pressure after changing engine oil ?

    If the Filter refuses to allow Oil to pass, there should be a Bypass that lets the Oil Flow, unfiltered to prevent Immediate Engine Failure. My 5.7 ran for over 100 hrs before it sounded like it had Mechanical Lifters, due to the Oil Cooler Lines being reversed, and the Anti-Drainback Valve in...
  13. jimmbo

    Alpha drive for a V8 whats the ratio?

    I suspect the WOT Range for the Fuelie 5 liter, is 4800 - 5200 rpm. Mercury was placing that Info on the Flame Arrestor Decal
  14. jimmbo

    Embarrassing question

    Extra Oil will not repair any scoring/scuffing if it has happened. If the Fuel-Oil was diluted to 100:1, the engine should be okay, the 50:1 ratio is more Critical at High Load High RPM
  15. jimmbo

    Embarrassing question

    A Compression test only reveals issues with the Cylinder, Pistons and Rings. It can't indicate any Damage to the Crank, Connecting Rod, Piston Pin Bearings or to the Crankcase Sealing Rings. The Cylinder Walls actually require very little Lubrication.
  16. jimmbo

    Embarrassing question

    If, and that is a Big If, the tank had 20 gallons of 50:1 premix and you added 20 gallons, the result would be in theory 40 gallons of 100:1, but that would also assume complete mixing of the old and fresh gas... How much time running was even the slightest bit above Idle?
  17. jimmbo

    Embarrassing question

    How long ago did you buy this potential Anchor, and did the Dealer put in Writing it was a 4 stroke, and was there any Warranty? I'm not going to assume there any Oil in the Gas that was already in the tank, but how much fuel was in it, and how much did you add?
  18. jimmbo

    Embarrassing question

    How much is "not much" and at what throttle setting?
  19. jimmbo

    Embarrassing question

    You are saying you ran it without Oil added to the Gas? And the Dealer/Salesman said it was 4 stroke?
  20. jimmbo

    '87 mercury outboard 115hp 6cyl

    I knew it as FUBAR %$#&%$ up beyond all recognition
Top