Search results

  1. Faztbullet

    20 hp Mariner No spark

    Broken ferrite could cause a miss but need to test to see if it will jump a min 3/8 air gap
  2. Faztbullet

    Boat not getting up to speed

    Check compression ...again, test spark on that cylinder, must jump a minimum 3/8 air gap
  3. Faztbullet

    Outboard running rough and I need help

    That is called "4 stroking" and need to rev up with advance arm so timing advances with fuel delivery.
  4. Faztbullet

    Johnson 150 Rebuild/Remanufacture Guidance

    Light oil on head bolt threads...peanut butter on bolts that torque under 180 in lbs
  5. Faztbullet

    20 hp Mariner No spark

    Top cover plate might cause it to idle rough.
  6. Faztbullet

    Prop problems

    The clutch pack an motor is what holds drive in position.....get you a manual to service and most parts are NLA.
  7. Faztbullet

    Merc 15 hp running LOUDER

    Yes you can spray it in there....on the noise look to see if anode above prop has came off
  8. Faztbullet

    94 fast strike idle issue

    It will do that when in Quckstart
  9. Faztbullet

    Prop problems

    Tilt motor or clutch system problems
  10. Faztbullet

    Cylinder Compression Incongruences.-

    As previously stated ..pistons show no signs of extreme overheating and the peeling paint is NOT from overheating. Where is pic of bored cylinders?
  11. Faztbullet

    Johnson 150 Rebuild/Remanufacture Guidance

    I wouldnt glue it. When I replace one I just put a dab of white thermal transfer grease on disk part and in hole and sock er in
  12. Faztbullet

    RPM won't go over 4000

    Disconnect the rectifier and retest...
  13. Faztbullet

    RPM won't go over 4000

    Is it stuttering like mechanic stated or runs good but no max RPM?
  14. Faztbullet

    Boat not getting up to speed

    What is good compression?
  15. Faztbullet

    Wondering about the need for "variable" oil mix.

    All the oil pumps on Merc are variable..even your OMS pump is variable.
  16. Faztbullet

    Boat not getting up to speed

    yes....need to troubleshoot. Start with compression test followed by spark test of each cylinder.
Top