Search results

  1. Faztbullet

    Gas leak gas freezeing

    Either not gas or a water gas mix(more water than gas)
  2. Faztbullet

    225 efi mariner 1996, excessive smoking at start up. The engine, not me!

    The older 3L motors that do this is usually one of two items. First is the oil pump shaft seal will walk out and leak oil into crankcase or secondly the crankcase check valve to oil tank is not bleeding off. The overpressures the oil system and cause oil to bleed into VST
  3. Faztbullet

    Rebuilding evinrude 60hp 60073D

    Need to have cylinders "miked' to see how much wear and out of round they are. Need to find a piston supplier also as not offered aftermarket...likely NOS parts.
  4. Faztbullet

    Thermostat housing hole.

    Be a good test if fuel actually flowed thru jet that direction...
  5. Faztbullet

    Delayed Ignition Fuel Pump

    Check kill tether?
  6. Faztbullet

    Evinrude 120 V4 Miss almost every second rmp

    Did you tear down carbs?
  7. Faztbullet

    1989 70 hp evinrude won't crank

    Is control box in neutral?
  8. Faztbullet

    Evinrude Black with white stripe wire

    Blk w wht is magneto wire. Tied into the solid blks off wire 3 in main harness Duetch connector
  9. Faztbullet

    Prop selection 1998 fishin barge

    You need a 19 pitch prop............................ with a 150HP attached to it.
  10. Faztbullet

    Mercury overheating problems

    You cannot test it correctly this way. If your house pressure is over 25 psi it will open the poppet immediately. It a 2.5 and it will NOT pee till the t-stats open. I reread your first post(below) and does the alarm work if you ground it out? The 2.5 have low PSI at idle(2-5 psi) and about...
  11. Faztbullet

    Mercury 225 Offshore- LOSING MY MIND PLEASE HELP

    Ending up it a harness problem
  12. Faztbullet

    Carb high speed orifice #'s

    🥇🏅🏆...Racer
  13. Faztbullet

    1999 Evinrude 115 Ficht - cold run issue?

    Sticky TPS? Failing AT sensor?
  14. Faztbullet

    merc 60hp 4stroke efi 2004 hard start when warm

    Check the fuel pressure when warm and acting up
  15. Faztbullet

    New Old Procraft Stalker s180 with Mariner 150HP oil injected engine

    That actually #1 and its a fairly easy fix. Most likely the idle stabilizer is bad the most common cause of failure of #1 on the 2L motors. Get you a FACTORY manual and a set of inside "mikes" to measures cylinders. Best bet is to bore all 6 cyls .020 oversize, new switchboxes,trash...
  16. Faztbullet

    1983 70 HP Carb issue

    The whitish fuel puddle is condensation and gas vapor..no big concern's. Is your sync and link correct and at least a 1/8 gap between roller and cam?
  17. Faztbullet

    Grease in distributor cap

    Someone has over greased distributer housing.
Top