Search results

  1. R

    is a 60hp outboard too small for this boat

    Johnson / Evinrude had a very good 100 HP motor in 1966.-----Battery 12 volt ignition and a bullet proof electric shift.
  2. R

    suzuki dt85

    About 1/2 the parts are listed as ---NLA --- for this motor.
  3. R

    1957 fd-11 johnson skeg part number?

    There are lots of good gearcases that would fit.----These motors were basically the same for 20 years.-----You local ---aomci---- member might have 1 or more.
  4. R

    1980 85hp johnson engine

    A missing bearing retainer bolt would allow water to get to #4 cylinder.----A bad lower crank seal would allow water to get into the #4 cylinder too !!
  5. R

    is a 60hp outboard too small for this boat

    Correct.---It is a 1973 model.
  6. R

    Repairing Coupling assembly

    Coupling assembly is on the flywheel.-----So yes , the engine must be pulled to get at it.-----BOAT = Bring on another thousand.
  7. R

    Prop not spinning

    See post #9
  8. R

    1966 Jonhson 9.5 rust around exhaust cover

    Exhaust manifold would get very got.----Paint on it is not burned !
  9. R

    1982 Johnson 7.5hp Backfires but No Start (Wrong Carb?)

    This motor gas a 6 HP carburetor from a 79 or older model installed.-----That is why it looks different from what is shown in the parts book for an 82 model 7.5 HP----Simple.
  10. R

    1966 Jonhson 9.5 rust around exhaust cover

    In my opinion this motor does not show overheating.----Severe overheat changes the colour of the white paint.
  11. R

    1966 Jonhson 9.5 rust around exhaust cover

    The parts are all aluminum castings.----Those do not turn a rusty brown.
  12. R

    1966 Jonhson 9.5 rust around exhaust cover

    The red appears to be the colour of the primer paint used on these motors.----Degrease the area and paint it.
  13. R

    Old evinrude junior ID

    Nonsense----The ---CD -----Means that it is a 1986 model.
  14. R

    Prop not spinning

    Serviced last week ???-----Call the mechanic to come and check it.
  15. R

    Prop not spinning

    Check the gear oil.--Post what you find.----Universal joint failed ?-----Perhaps coupling spline failed.
  16. R

    building a full cabin over cockpit

    If you look at some maritime disasters you will find in the reports that.------The new owner of the ship made modifications / added cabins and made the ship top heavy.-----So be careful of you start adding bits to change a boat.
  17. R

    My old Motor

    The future is not affordable !-----Your take home pay will hardly get you home.
  18. R

    My old Motor

    On top of that in some areas the marina is a seasonal operation.----Hard / expensive to keep qualified mechanics on payroll in the off season.-----So yes the smaller dealer in a cottage / fishing area may have trouble repairing these high tech machines.
  19. R

    is a 60hp outboard too small for this boat

    About 120 HP would move that boat nicely.------And 20 HP would be nice for fishing " performance" so to speak.
  20. R

    My old Motor

    Find the----aomci-------I believe there are folks who have a book with serial # listings.----I used to have a copy of that book.
Top