Search results

  1. R

    2004 Merc 2 stroke 90HP seized after rebuild

    Up to you to do the inspection.-----Water pump and carburetors.------Find the cause or you will ne rebuilding it again and again.
  2. R

    50hp electric start evinrude reverse issues

    The model # tells me it is a 1981.----Time to take the lower unit apart for inspection and repair as needed.
  3. R

    50hp electric start evinrude reverse issues

    You are sure it is not a 1981 model ?----Check the gear oil.-----I would remove lower unit and check shift rod height.
  4. R

    1974 evinrude 6hp coughing

    You have not installed a new impeller ?-----I guess I missed the fact that you tried adjusting the mixture in post #1----Sorry.
  5. R

    Clicking or clunking no gear

    Check gear oil.
  6. R

    90 hp 2 stroke 1998 Merc Poor Performance

    Yes , it could be a broken reed valve or one stuck open.
  7. R

    1974 evinrude 6hp coughing

    Open the low speed mixture needle 1/4 turn at a time.----Inspect thermostat as they are often missing or stuck open.-----Does spark jump a gap of 1/4" on both leads ?
  8. R

    50hp electric start evinrude reverse issues

    Is this a 4 cylinder 1959 model ?
  9. R

    1986 4 hp Evinrude poor idle

    Put new reeds / reed plate in and test run.-----I truly believe it will get rid of the sneezing / cough.
  10. R

    Fuel Solinoid primer

    Yes there is a fuse for power supply to you key.----
  11. R

    1968 Evinrude 33hp engine issue

    Are you testing in a bucket or with boat floating in the water ?
  12. R

    1986 4 hp Evinrude poor idle

    Compression on 2 strokes can be and is a mystery to some.----But 100 PSI on this motor is fine !----What other trouble shooting has been done. ?-----Does spark jump a gap of 3/8" on both leads ?----Is the high speed orifice clean ?----Is the fuel pump bladder ( orange bit ) in good shape...
  13. R

    Easiest to crank manual winch

    Put a pulley on your hook .------Bring the cable back to the winch post.----Gives you double the pulling power with the winch you have now.
  14. R

    Draining Mystery Water

    I would remove the plastic drainplug plate.------Inspect that.-----Reinstall the 3M sealer 4200 or equivalent.
  15. R

    Cranking engine by hand

    Is the starter working properly?-----How did seawater get in there ?
  16. R

    9.9 Spewing Fuel

    The little square pumps were used on 3 HP models and up to the 22 cubic inch 25 HP models.-----A $7.00 diaphragm is all that can be needed to restore the pumping efficiency of these ultra reliable factory pumps.----I would never resort to buying a new one of any kind.
  17. R

    BRP reveals a new style of outboard, Rotax powered, horizontal crankshaft....

    4 stroke outboards are amazing.-----But I have seen many in the scrap heap.----Too many parts and major repairs can not be done economically.
  18. R

    Fresh bore and 125 psi on one cylinder??

    ??----Rejet / larger orifice for the carburetors.
  19. R

    BRP reveals a new style of outboard, Rotax powered, horizontal crankshaft....

    Agreed ROTAX , is not something new.-----The general public perceives 2 stroke to be an inferior product.
  20. R

    BRP reveals a new style of outboard, Rotax powered, horizontal crankshaft....

    Seems ready for change over to an electric motor.
Top