Search results

  1. R

    Outboard will only start when given 10%-30% throttle. Will not start when given full throttle or half throttle.

    Is this on your 100 HP motor ?
  2. R

    2002 johnson 115 2 stroke starts then dies, heavy smoke.

    Sorry , I missed that location first time. --Drain carburetors as they may have too much oil in them.-----What oil are you using.----Is the vent clear on the oil tank.-----replace the cap on oil tank or leave it cracked open.
  3. R

    70hp Johnson 2-Stroke 3 Cylinder

    Check neutral switch in control box.---Check ground wire on the solenoid.
  4. R

    06 Johnson 90 2 stroke slow activation

    You are sure that motor is not mounted too high ?----Was water pump serviced recently ?------You are now running with temperature warning horn bypassed ?----Any other trouble shooting done.-----What fuel pump is on the motor now ?
  5. R

    2002 johnson 115 2 stroke starts then dies, heavy smoke.

    Why is it difficult to find a mechanic ??----Your location ?
  6. R

    Starflite 3 fuel pump and other hose routing.

    75 HP-------Lots of power, uses lots of fuel.
  7. R

    Young kid looking for advice!

    pull the flywheel and go through the magneto.------leroysramblings----Is your teacher on these motors
  8. R

    Johnson 150 v6 leaking gas at idle

    Screws for the carburetor bowl are 10 inch-lbs .-----Other 1/4" screws are 80 inch-lbs.----Then 5/16" screws are 120 inch-lbs.
  9. R

    Hi All! I have 68 Evinrude 55hp 66872 R

    An original 1968 model 55 electric shift control box did not have a ----PUSH THE KEY IN -----Choke feature.-----There is a separate choke switch.
  10. R

    2002 johnson 115 2 stroke starts then dies, heavy smoke.

    The red lever should be in line with the valve body to run.----When you turn that lever it opens the valve and sprays fuel into the engine.----So have the red lever inline with valve body.----Push key in and hold it in while cranking the motor for cold start.----You should find an owners...
  11. R

    Gas tank pressure fueling up!! 🤬

    I would say the vent screen or hose is plugged.
  12. R

    OMC sterndrive not moving in gear.

    You turn one ( input ) shaft a full 10 turns.-----And you count how many turns the output shaft turns.----Simple enough in my opinion !!
  13. R

    No spark on my 1984 115 horsepower TOP

    see post#4
  14. R

    No spark on my 1984 115 horsepower TOP

    Key needs to be pushed in while cranking it over.----Battery should be load tested even if new.----Starter motor should be taken apart and inspected / ohm checked.-----Motor needs a new impeller before launching the boat !
  15. R

    1984 Evinrude 235 cylinder head cover torque

    There are oil recirculation hoses.-----And there are wee hoses from the electric primer valve..------Electric primer VALVE is used for cold starting.-----Key is to be pushed in while cranking it over for near instant starting.
  16. R

    2005 115 Johnson PLSOR dies at idle

    There may be a leak in your tank.----Simply test run with another tank.----Borrow one if you have to.----There is nothing scary about carburetors.----And this issue might be as simple as turning idle mixture screws a wee bit.-----Wonderful time to learn or pay $120/ hr at the shop.
  17. R

    1984 Evinrude 235 cylinder head cover torque

    I have 2 ( 1982 ) of these motors on my boat.----If compression was 75 PSI on them they would come apart in a heart beat !!!-----Install a new impeller before launching the boat.
  18. R

    First start of oil injected 2 stroke after sitting for 4 years

    Too much oil will do no damage to the motor.-----Owners of oil injected motors need to test / keep an eye on the injection system.
  19. R

    1984 Evinrude 235 cylinder head cover torque

    The 1/4-20NC bolts are 60 to 80 inch lbs.----inch-lbs
  20. R

    under powered mercury 125 / 2 stroke

    What boat ??
Top