Search results

  1. R

    2005 115 Johnson PLSOR carb floods for no apparent reason

    It is totally normal for the bulb to be soft when motor is running
  2. R

    2005 115 Johnson PLSOR carb floods for no apparent reason

    That round gasket / washer may not be used on plastic carburetors.
  3. R

    Lower unit filled with grease

    Post question about ignition right here.
  4. R

    2010 Mercury 50 2 stroke is not charging the battery. Where is the alternator located ?

    Battery charging windings are under the flywheel.-----Can be tested without removing the flywheel.
  5. R

    Winner manufacturer and parts

    No seam between hull and cap ??----The one I did had those individual flotation pieces packed under the floor.----About the size of a small loaf of bread.-----And there were many of them.
  6. R

    89 evinrude wiring around the power pack

    What motor ?------What powerpack part # did you order.----From a dealer or from an " online " parts seller ?----Why are you replacing the powerpack.-----Just hoping it is the part needed ?-----Any testing / trouble shooting done on your motor ?
  7. R

    125 Force Outboard won’t achieve full power

    How can the low speed mixture being too lean , cause a melted piston ??
  8. R

    125 Force Outboard won’t achieve full power

    Not sure how a lean low speed mixture can destroy / cause melted pistons on a motor.
  9. R

    Lower unit filled with grease

    I have said it many times.------Lubrication and how parts " work " with lubricants is not well understood.-----Grease is not the proper lubricant for a 25 HP 3 cylinder gearcase !
  10. R

    2000 E150FPXSSM LOOSES IGNITION ON START UP

    Perhaps issues with " power distribution " module.----Bunch of relays and fuses in there.----Item #67 ----586754 ?
  11. R

    Ran outdrive without lube! Bad sound.

    A good test case.---Left a 90 HP powerhead out over last winter.----New block / new pistons and rings, parts oiled 5 years ago..----Crankcase open and heads off.-----Covered with garbage bag and motor cowling.-----Out in the rain / swirling snow and minus 20 temperatures.------Took it apart...
  12. R

    Ran outdrive without lube! Bad sound.

    Used to be a member of a car club at one time.-----Arrived at the clubhouse / garage / workshop.-----Good friend there said ----" glad you came by , I need to go get 4 quarts of oil to finish my oil change "------Yes , he dumped in the new oil with drain plug out.----Mistake that has been made...
  13. R

    1976 Johnson 70hp will only run low rpm after warming up.

    There may be a service bulletin regarding carburetor issues on that motor.
  14. R

    1974 Evinrude 25hp wont run.

    Agreed----You need to review your choice of sparkplug for this motor.
  15. R

    Having trouble identifying Model/Year

    The 90 and 88 HP models are the same motor.-----The 88 " special " was marketed at a lower price without VRO and power trim / tilt.----And clearly lists a non VRO fuel pump for the 88 HP version !!
  16. R

    2000 25 hp Johnson 2 stroke

    The---- " sneeze "--- Might occur in the exhaust housing.-----The sudden rise in pressure pusher water down and out of the exhaust housing.-----Then water floods back in and makes strange sounds I think.
  17. R

    Starter problems

    Have your battery load tested.----Even if it is new.
  18. R

    Having trouble identifying Model/Year

    I would guess it to be a 1988 model.------Marketed as an 88 HP special.-----Same as a 90 HP but often with no oil injection or power trim / tilt.----Well at least the powerhead is 1988.-----The rest could be a different year.
  19. R

    1976 Johnson 70hp will only run low rpm after warming up.

    Are compression values up around 140 PSI ?-----Does spark jump a gap of 3/8" on each lead ?----If you have original steel tanks they are sealed.-----But when you attach the fuel hose there are 2 small pins that are pushed in.----They are valves.-----One lets fuel out of tank and other is the vent.
Top