Search results

  1. C

    wot ?

    Hi, anyone I haveEvinrude 1964 2 cylander 28hp. I rebuilt carb, put in new tune up kit, set points, checked compression 105and104, got motor started and idle fine before winter 2009.Today i took it out for a spin, it seem to run fine at low and mid range speed. then I adjusted high speed...
  2. C

    Does not runat full throttle

    Hell, Anyone I have 1964 evinrude 2 cylinder 28hp. I rebuilt carburator, I took a boat out for testing Saturday. It idles perfect, but when I tryto run at full throtle seemed like It does not rev up at all, by sounding of motor. The motor seems to run at low speed like 5 mph. It run good...
  3. C

    engine coughs after replaced fuel pump.

    Hello, everyone I have 1964 28 hp 2 cyl, model#28402m. I replaced fuel pump, now the engine keeps on running, except it coughs once in a while. what would be a cause? any hints, info will appreciated. ps, coughs at idling only. Thank you.
  4. C

    Alcohol resistance fuel lines?

    Hi, All I am working on 1964 evinrude 28 hp. I like to replace fuel lines. they still looks good. how do I know if fuel lines on my motor are not alcohol resistance. what do they look like?, Thank you.
  5. C

    throttle shift lever resume original position?

    Hello, me again, I am working on 1964 28hp, 2 cyl, model# 28402M. I have a question on throttle lever that return to in between start and low position when I push throttle to ( HIGH or REP UP ). Is that normal for this model ?. I never have this old motor before. I see newer models...
  6. C

    filter bowl emty out fuel and die?

    Hello, every one, I have 1964 evinrude 28 hp, 2cyl starts and runs until a filter bowl runs out of fuel and dies. It will stars & runs if I prime a primer ball again. Is that a sign of bad fuel pump?. any inffo will be apreciated. Model# 28402M.
  7. C

    fuel squirtting out a carb?

    why fuel squirts out of a carb when keep squeezing primer ball? Carb had been cleaned and installed a new kit . motr runs when choke pull manually for a short time then have to prime agian to get it started and running. thank you.
  8. C

    fuel squirts out a carb?

    hi, why fuel squirtting out a carb when keep squeezing primer ball ? The had been cleaned and putting in with a new kits. motor run if manually choke it. thank you.
  9. C

    points operations?

    Can any body explane the operations of points. When is it sopposed to close and open fo 1964 28hp, 2cyl Evinrude. Thank you.
  10. C

    Ignition coil Measurement?

    Hi, I have a suspect ignition coil. How many ohms should get when i put ohm meter test leads on both terminals? It is for 28hp 2cyl evinrude. any ideas ? Thank you.
  11. C

    Evinrude 1964 28hp will not start

    Evinrude, Moldel# 28402M, replaced condensors,points adjusted to .02spec took carburator apart soak cleaned and replaced with carb rebuild kit. Also new spark plugs gapped to .03, give a try had a few of back fires and started For 2 second and now just crank. Thank you.
  12. C

    Lower unit?

    Removed lower unit from 1964 28 hp. do not see o-Ring on top end of driveshaft. Is it possible stuck in side the engine? How many seals and o-rings I need to replce with impeller? Manual shows 1 o-Ring and 1 seal on top only. Thank you
  13. C

    Evinrude,Model# 28402M,S/n E02487

    Looking for junction box cover. Is there a place to get that from?. Thank you,
  14. C

    Tune up kit for 1964 M0del# 28402M

    Hi, planing to replce all electrical components under the flywheel. Just wonder if the tune up kits include coil,condensor, points.. etc That i need to replace. I have Seloc service manual does not cover pacific model. Thank you.
  15. C

    1964 Evinrude, Model#28402M, s/n #E02487 a hole above gearcase housing.

    http://www.verizonwireless.com/pictureI want to insert Pictures from cell phone but, unable to do it yet. By the way by comparing 1962 johnson motor to my, there is no hole on Johnson. My has 2 # 14 holes, 1 of # 24 which is for pivot assembly, And 1 additional hole right above gearcase...
  16. C

    1964 28hp tune up kit/

    Hi, I want to do tune up kit for the old motor. Is every thing under a fly wheel?. thank you.
  17. C

    Finding screw for old 28 hp Evinrude 1964.

    Just got an old 1964 28hp,2cycle,2cylinder. Model#28402m. Looking for L U drain/fill screw. The one comes with it does not seem to fit right. Is there any where to buy it. modify it?. Thank you.
  18. C

    how to diconnect L U.

    Hello, I have 1964 speedtween cylinder, 2cycle and 28hp. I try to disconnect the L U, It was stuck in gear before, now I disconnected cable, put it in reverse, it dropped down about 2". That is all i can lower it. where and how to disconect the shift rod from the motor? I can not see a...
  19. C

    running motor with ears muffs.

    Can I run my 1964 28 hp 2cylinder, 2 cycle with ears muffs?. Because, I do not see the holes to insert the ears muffs. Is there an option without using the water tank. Thank you.
  20. C

    spark?

    I have 1964 28hp, 2cycle, 2 cylander. Checking for spark. only have spark on top plug, but not on bottom plug. Is that normal? Thank you for any comments oppinions.
Top