Search results

  1. L

    Boat stringer replacement

    I have a wellcraft coastal I had stringers replaced and he probly screwed that up and the shop didn’t replace My floor joist next to them I don’t think I can fight this battle with this guy so I’m looking for another recommendation for a reputable shop to take care of this for me
  2. L

    Getting new stringers engine install

    I am getting my floor and stringers done and transom if needed.i have 1989 5.7 mercruiser when I get the boat back what is the beat way to line everything up before I drill holes in my new stringers so everything lines up
  3. L

    alpha one lower unit weep hole

    I have a generation 1 alpha one and oil coming out of the weep drain hole. I pressure tested it and plugged the oil seal hole doesnt lose air. When i hook up a hose to the weep hole and blow into it air comes out of the shift shaft seal.area. Does that mean that the shift shaft sea;l is bad...
  4. L

    bypass main wire harness on 3.0

    I have a 1989 mercruiser 3.0.It wont turn over or no power at the helm. I f I unplug the main wire harness what two wires will I need to jump to get it to run if I jump the starter to get it to crank. The boat is salvaged so just want to get the engine to run and then pull out.
  5. L

    5.7 knoicking in gear at 2500 rpm.

    I have a 5.7 with alpha one 1989.I replaced the outdrive so its not that. When I out it in neutral and hogher rpms it runs great. Put it in gear can hear a knockin the back of the engine. I replaces the outdrive so I know its not that. When I have it on trailer it does not make the sound but...
  6. L

    sport-craft VS, Wellcrcraft

    I have been looking at a 1988 sport-craft 250 fisherman. I seen they have been out of bussiness for a while and would like to know if theres major issues with these boats or what. The other boat I am looking into is a 1983 Wellcraft 248 sportsman. I know there two different boats but might one...
  7. L

    alpha one milky oil in pump

    I have a alpha one outdrive unit and have noticed the oil is milky. I have checked the connections with the hoses and they seem tight. Can it be something else besides replaceing the seals in the cylinders thats what my next step is and looking for other ideas or if someone else had this...
View older results
Top