Search results

  1. Grub54891

    Can the base of engine work? Two to bolts under engine are rusted and can

    If it slides in with little effort it’s good. Let’s see the entire shaft after you pull it out.
  2. Grub54891

    Can the base of engine work? Two to bolts under engine are rusted and can

    If it doesn’t turn in any direction you have the wrong bearing. I looked back at your pics, it does look like the correct bearing. Try this: put the alignment bar in, but not engaged wi the coupler. Lift up on the bar. I bet it moves the bearing. Some are rather stiff, but do “ gimbal “
  3. Grub54891

    Can the base of engine work? Two to bolts under engine are rusted and can

    Tap the alignment bar up, down and side to side. That centers the gimbal bearing. Be sure the bar goes in all the way. Use a dead blow hammer to tap it. Then check the alignment.
  4. Grub54891

    Built an electric jetski

    Go with cogged belt drive.
  5. Grub54891

    Can the base of engine work? Two to bolts under engine are rusted and can

    As I said, the bar should go in further. So no it’s not aligned yet. You may be close but not close enough.
  6. Grub54891

    gas prices

    We still have about half of the boats on the hard at the marina. We had to start launching late as the ice and weather didn’t like us much. Still alot of them haven’t asked to be launched. Strange season so far.
  7. Grub54891

    Can the base of engine work? Two to bolts under engine are rusted and can

    Your alignment bar should go all the way in to the step on the shaft. If you don’t have issues shifting, the cables are ok.
  8. Grub54891

    Bow/Hull access 2002 Tracker Tahoe Q3

    Remove the interior in that area. Other than that you may have to put a deck plate in the area that fits a 6” hole you may have to drill.
  9. Grub54891

    First Boat -- Needs Repairs; Havent Even Drove it Since Signing

    Well... It depends on the type of steering, does this pontoon have a I/O or outboard? If it has a SeaStar helm, it somehow got low on fluid, which is no big deal to repair, as long as they fix the leak, and bleed it out properly. If it has an I/O and the steering cable, along with a power...
  10. Grub54891

    Has anyone seen or heard of a trailer tire doing this?

    Why do that? Just block the axle up and the weight won’t be there.
  11. Grub54891

    Air conditioning water supply not pumping

    When launching the first time of the season, sometimes you may have to prime if the pump is to high in the bilge. After that it should be fine. If not something isn’t right.
  12. Grub54891

    Looking for smoother throttle

    Also, with the new style cables, they don’t need lube. The sheathing on the inner cable is the lube. Grease or anything else just gunk’s up over time and makes them sticky.
  13. Grub54891

    Can the base of engine work? Two to bolts under engine are rusted and can

    Yes that cable will fit. Again, did you hammer on the outside race of the bearing or the inside race?
  14. Grub54891

    Can the base of engine work? Two to bolts under engine are rusted and can

    No. It looks like the gimble bearing isn’t seated in all the way. Using a stick to pound it in on The inner race will ruin it. You need the proper installation tool for the bearing and alignment bar.
  15. Grub54891

    Water pump

    Sure, put it on there. it won't hurt, it will help seal it. Also, if the bolt holes are drilled to the water jacket, they should have sealant on the threads. This will prevent leaks wicking up the threads. Can't remember if those are blind holes or drilled through right now.
  16. Grub54891

    Looking for smoother throttle

    Interesting. Are there any sharp bends in the cables? That would make it stiff. On my mercury outboard, it’s a bit stiffer than my I/O is.
  17. Grub54891

    Looking for smoother throttle

    *Some* Throttle controls have a tension adjustment. Have a few pics of your controls?
  18. Grub54891

    Head with no holding tank, is this illegal?

    If you are in the great lakes, you better have a holding tank or get fined.
  19. Grub54891

    Trailer lights troubleshooting help

    Glad you found it. I’ve installed led lights on two of my trailers. Also ran the grounds completely to the lights. No issues three years later.
  20. Grub54891

    Trailer lights troubleshooting help

    I run the grounds to each and every light. You can’t trust the the trailer to complete the grounds.
Top