Search results

  1. Scott Danforth

    Very Low Compessions on Mercruiser 5.0 MPI Engine. with Exhaust Manifold, Thermostat Housing Removed.

    I would pull the motor and tear it down. My guess is you need a new bobtail If the motor was submerged, the steering cable, wiring harness, and rotating electrics will need replacement as well
  2. Scott Danforth

    Older Ranger Inboard

    Know your firing order before looking for parts. The marine 302 had 2 firing orders. The 302 camed ones had the 302 firing order. The ones running a 351 cam had the 351 firing order
  3. Scott Danforth

    oar lock bushings

    uhhhh,..... hence the link in post #3 to the flanged bushings of the size the OP was looking for in post #1
  4. Scott Danforth

    what to use to line ski locker

    this is along the lines of what was in my searay. https://www.walmart.com/ip/Chaparral-Boat-Non-Skid-Mat-HAR28GR-59-Ski-Locker-Gray-Rubber/1364016414
  5. Scott Danforth

    Outdrive cannot clean

    yes, and you need to neutralize the corrosion, then use an etching agent or an etching primer.
  6. Scott Danforth

    DIY - Canvas Enclosure

    Hey Ted, wanna make side and front curtains for another Cruisers....... I can send the patterns. ;D
  7. Scott Danforth

    Easiest engine drop in replacement for 1986 MCM 470

    yes, the 3.7 uses a GM flywheel bolt pattern same as 4.3. you do have to change the u-joint shaft. the 3.0 is under powered and nearly the same weight as the V6.
  8. Scott Danforth

    95 Four winns 5.8L OMC Cobra

    none of the fuel injection parts are available. so when it breaks, you have to convert to carb. Ford went out of the marine business about the time your boat was new. OMC went out of business probably as they were pushing your boat out the building. we normally tell people avoid ford and...
  9. Scott Danforth

    1998 Rendova 14 foot tender

    Just an FYI, most hypalon boats last a max of 20 years. yours is pushing 27
  10. Scott Danforth

    what to use to line ski locker

    When I had an early boat with a ski locker, I had glued in carpet that was changed to glued in urethane sheet. SeaRay had a light grey/off white rubber grid-like mat like you would find in a shower EVA (like seadeck) would probably work well. line-x works well too
  11. Scott Danforth

    VOLVO PENTA OUTDRIVE DROPPING INSTANTLY

    no, its generally not installed
  12. Scott Danforth

    Wrong year on title

    FWIW, my old SeaRay 190 was a late 2001 build registered/sold/titled in Wisconsin and then Florida as a 2002
  13. Scott Danforth

    Battery switch not starting on 1, starting fine on 2 and All

    Its up to you, I personally would sort it out before you become a headline in the Page AZ newspaper " boater body found, been missing for weeks"
  14. Scott Danforth

    Wrong year on title

    Have you contacted Michigan?
  15. Scott Danforth

    1973 mercruiser 120 HP no spark

    When did you add the pertronix? And has it ever run?
  16. Scott Danforth

    Are you ready to puke?

    Remember, the stringers rotted years before the floor. Long before plywood and screws, you need to build a cradle, buy a bunch of tyvek suits, and cut out all the rotten stuff and grind ... grind....grind
  17. Scott Danforth

    Trim switch wiring review

    the factory volvo penta drive service manual has a fantastic wiring and troubleshooting section in the back towards the index
  18. Scott Danforth

    Outdrive Pressure test Question

    You most likely have to contact them because they pulled the info for stuff 25+ years old a few years back There should be an email link
  19. Scott Danforth

    replace coupler or not?

    Those teeth are shot. Go to Napa and get a new ring gear
  20. Scott Danforth

    Mercury thunderbolt 110, no spark

    first, welcome aboard on a 2-stroke with magneto ignition, you ground the ignition to kill spark. that is what the kill switch does.
Top