Search results

  1. Scott Danforth

    1993 OMC 5.8 EFI Idle problem, runs on throttle, too rich

    Can always yank the EFI BS and drop in a holley 650
  2. Scott Danforth

    Battery upgrade on Kayak

    Your minn kota will draw 45+ amps, turning the 10 gauge wire into a toaster element You will need 6 gauge wire
  3. Scott Danforth

    Renovating the deck floor top layer

    Page 13 of the link in my sig show how to roll a non-skid texture using gel/fumed silica
  4. Scott Danforth

    Engine ID

    As far as which bearings. 90% are 2-bolt bearings. Run the block casting number and you will find it listed for both The block casting number will also tell you if your block is a 1980-1984, 1985, or 1986-1987. 1985 and later is 1-piece RMS with perimeter bolt valve cover, 1986-1987 is center...
  5. Scott Danforth

    Hard Cover on Pontoon

    Need more information. Each manufacturer used a different system
  6. Scott Danforth

    Attaching Rubber Fender List To Side Of Solar Cell Driven Catamaran

    I would put on a rub rail and rub rail insert. Take a look at TACO marine
  7. Scott Danforth

    Bluegill

    They are, however didn't want to deal with scaling/filleting them on this trip
  8. Scott Danforth

    Bluegill

    Past weekend was in Sturgeon Bay Wisconsin with my buddy. Went out for bluegill to just get some action on Clark Lake Hit a dozen that were bigger than our hands.
  9. Scott Danforth

    99 Monterey 276 Transom Replacement

    good luck, I would personally fix the transom this winter
  10. Scott Danforth

    Everything done but low rpm at WOT. Distributor spring?

    If you were in Florida, I would loan you a bigger carb to try
  11. Scott Danforth

    P.S.A. . . . SAE J2807 Towing capacity spec's

    Means Ted was bored and was googling stuff
  12. Scott Danforth

    Fix hatch window on older boat. Options?

    Measure the hatch glass, see your local plastic manufacturer, make a copy, spend a weekend rebuilding the hatch. Will cost you about $100 Or look on sites like great lakes skipper You can also Google hatch repair glass
  13. Scott Danforth

    Boat starts perfect but shuts off after 20 mins of driving

    You will have to manually/mechanically clean the fuel system There is no shortcut. There is no mechanic in a can
  14. Scott Danforth

    Nerding out on seat cushion foam...what to get

    See your local upholstery supply house or your local upholstery shop The P65 or P80 is the density of foam Look at reliatex or similar supply houses
  15. Scott Danforth

    Maybe my turn for new boat time

    My guess is you have a 40cc. I would go up to 50cc. (Based on prior post) Would need to get numbers off helm
Top