Search results

  1. Scott Danforth

    If water comes out of propeller it means thermostat opened and water pump working?

    The thermostat in a marine motor is used as a mixing valve. There is always water being pumped into the motor , the thermostat may or may not divert a small amount of water thru the motor,, however water is always flowing out the exhaust to keep it cool and from burning up your boat
  2. Scott Danforth

    1989 Mercruser 5.7 will not get over 2000 rpm

    Your motor doesn't care if you have an oil pressure gauge or not That is not your problem
  3. Scott Danforth

    Stalling and Starting problems

    Covered in the factory service manual
  4. Scott Danforth

    Stud below inner Transom plate

    Start googling IMO and USCG websites and regulations on bonding and learn about one of the most important systems on a boat
  5. Scott Danforth

    3.0 Long Block - Cracked - Any Value?

    Check with your local machine shop. There may be core value in the crank and head
  6. Scott Danforth

    Saltwater corrosion = can't remove part

    Mix ATF & Acetone it's the best penetrating oil on the planet
  7. Scott Danforth

    Fiberglass Question

    The wood is structural Probably not related to the wall. Boats rot from the keel upward. How are the stringers and transom?
  8. Scott Danforth

    Stud below inner Transom plate

    If the wire is green, it's a bonding screw
  9. Scott Danforth

    Volvo penta shift cable locking cable pin?

    89 is AQ series of drives Need pics to determine which parts. Or go to www.volvopentastore.com and look up your motor/drive for the parts breakdown
  10. Scott Danforth

    My boat is being a boat . . .

    Axius is the system on petrol engines that has the steering, throttle and gear system that allows the joystick
  11. Scott Danforth

    Carb Spacer

    All carb spacers have a gasket on each side.
  12. Scott Danforth

    Procedure to drain and refill closed antifreeze on 5th gen Volvo Penta 4.3?

    unfortunately manuals in the 50's had how-to to adjust ignition and set valve clearances. Todays manuals have to tell the person not to drink battery acid. In Volvo's defense, the average DIYer thinks youtube vids are accurate. I agree that maintenance should be part of the owners manual...
  13. Scott Danforth

    mercruiser 5.7 350/260hp alpha one outdrive starting issues

    I would stop throwing parts at it and start diagnosing. most of the time your old carb may only need to be gone thru. the "remanufactured" QuadraJet carbs you buy may actually be worse than your old carb. Start with verifying spark measure fuel pump pressure (should be 4-7 psi) verify engine...
  14. Scott Danforth

    What is this salt on my outboard block and spark plug holes?

    should have changed the impeller when you had it apart. sand will kill the efficiency of the impeller. Overheats kill the motor. do a compression check. If you overheated enough for the motor to quit. you most likely you collapsed the pistons or scored the cylinders.
  15. Scott Danforth

    rebuilt 3.0

    yes, unless you changed the cam to a roller cam. you need zinc in the oil. either buy oil with zinc in it, or add zinc to oil that doesnt come with zinc
  16. Scott Danforth

    Just thought I'd share a nice photo.

    My guess is Joe leaving his house out the back door made the news.....
  17. Scott Danforth

    1992 Grumman Sport Deck

    First, Welcome aboard Second, since the rub rail is probably TACO rub rail. search the TACO marine website. https://tacomarine.com/rub-rail
Top