Search results

  1. Scott Danforth

    Help Please!

    Measure the old distributor and go to NAPA. they have dizzy bushing in stock, however they are listed by ID and OD Also, to replace the bushings in a dizzy is a 30 minute job if you never did it before and a 10 minute job if you have done it once. knock the roll pin out of the dizzy gear pull...
  2. Scott Danforth

    How much did a 2008 19' alumaweld stryker sport jet cost brand new in 2008?

    boat values ebb and flow with the market. they dont "retain" value any more than your house or a car. Boats have a finite life determined when they designed it.
  3. Scott Danforth

    Can you use car oil in a Mercruiser 3.0 engine

    You need zinc with a flat tappet cam. you can use this over-priced oil. I run Rotella T4 15W-40 Diesel oil myself
  4. Scott Danforth

    Can you use car oil in a Mercruiser 3.0 engine

    make sure the oil for your flat tappet motor has zinc in it
  5. Scott Danforth

    1993 4.3 engine oil type

    dead dinosaurs or group IV PAO base oil derivative
  6. Scott Danforth

    trim tabs or not?

    every boat should have a set of Bennett trim tabs. I made a set for my Wooster Hellion before I sold it all single drive V-hull boats wander at low speed. two ways to fix that. go faster, or go with twins with counter-rotating props. v-hull wander is from the prop pushing the stern sideways...
  7. Scott Danforth

    First Start of the year and High Oil Pressure

    fresh oil, or did you not change oil before winter storage? pressure relief on SBC is 78 lbs. with bearing clearances, etc. a gauge normally reads less not uncommon to see high oil pressure on cold start up as oil viscosity is higher. 80 psi is nothing to worry about. let the motor run...
  8. Scott Danforth

    87 liberator motor mount/stringers

    Do all the tear down first. Being a 36 year old boat, I see a full hull restoration
  9. Scott Danforth

    Transom repair ?

    Welcome aboard Go to the 4th sticky at the top of the forum and read links 14, 15, 18, 2, 3, 4a, and 4b
  10. Scott Danforth

    Belt Size or Part # for a 1985 Mercruiser 3.0 Alpha One Gen One

    The mechanical pump is under $50 and will last decades. A marine rated pump, oil pressure switch, relay, relay socket and wiring will cost over $110. That pump is against USCG regs
  11. Scott Danforth

    V Drive trans oil analysis 1999 380 DA

    Metal in oil means the trans will soon need a rebuild.
  12. Scott Danforth

    Lost gearage?

    you cant mix Gen 1 and Gen 2 parts. But you can swap the whole transom shield AND drive AND coupler, etc.
  13. Scott Danforth

    Synching a 2000 Mercruiser MPI 350 to NMEA

    Look at Maretron for one of their gateways
  14. Scott Danforth

    Synching a 2000 Mercruiser MPI 350 to NMEA

    What are you trying to see?
  15. Scott Danforth

    Oil in bellows

    It's gear oil and water mixed
  16. Scott Danforth

    MerCruiser 5.0 MPI diagnostic connector

    Boat motors do not use the automotive ALDL connector or OBD software You will need Rinda software Many things can be diagnosed easy without plugging in. What is the motor doing or not doing?
  17. Scott Danforth

    5.7GXI age/value

    factory serial number on spark arrestor cover will bring you back to the factory engine. check the side of the block for a builders tag if its a reman or the serial number tag on the block next to the starter
  18. Scott Danforth

    1997 PCM PLD 5.8L parts

    If you cant get prestolite parts, you can always change to a mallory dizzy.
  19. Scott Danforth

    Can anyone identify this model ANGLER?

    what does the paperwork (title and registration) say it is?
  20. Scott Danforth

    Oil in bellows

    pressure test the drive. most likely the input seal is bad
Top