no, different generations of drives, transom shields and motors
your 1996 Searay should have a Gen VI motor with a post 1992 Bravo
your 1989 Maxum may be an alpha drive, the motor is a Mk 4, and the drive/transom shield, etc. are pre 1992
you didnt answer the question.
if you attempt to put the outdrive in a bucket, the bucket has to be big enough to get the whole boat in it to submerge the raw water pump far enough for it to prime. not just cover the intake, however get the watter above the pump
otherwise you simply burn up...
welcome aboard
if you have a bravo, you could swap to a complete BBC bobtail
you also need the y-pipes from a big block as the motor is about 4" wider than the small block
or you can also go to a 6.2 liter long block and just swap the 377 for the 350 which would be the easiest
original distributor would be points distributor.
hence the purple resistor wire from the run feed and the purple/yellow wire going to the I/R terminal on the starter for the start feed.
so what ignition system do you really have?
Sorry to hear about the passing of your husband.
Agree with Brian, pics would be needed at a minimum
Minnesota is coming up on the end of their boating season as the temperature will start plumeting shortly and ice fishing season will be starting. prices will be low compared to the spring...
for my typcial boat launch, I have an hour trip from where I launch to the ICW (about 24 miles). from there, usually 2-3 hours of tooling around, then a few hours of anchoring.
total trip is usually 6-10 hours (about 60-100 miles)
no way I could use a boat like the ARCBOAT as its...
inside the bilge, about 1" above the inside of the bottom of the hull. start by drilling 3-4 inches away from the transom drain plug. drill about 3/4" deep. then move outward about 6" and repeat.
also drill into your stringers, suggest 2-3" up from the hull
if your shavings are light...
what are "good OEM spec marine parts"?
you mean the marine stuff bolted to the outside, or the stock GM truck parts that make up the long block? the stock flat top pistons with the 4 reliefs?
the XM268H is a good cam, however not needed with stock drive, stock wet exhaust. what drive and...
