Search results

  1. Scott Danforth

    should I use a support for my outdrive on my H190?

    load paths for an outboard and an I/O are different. so are how the tilt/trim works. with your outboard, yes, a motor defloperizer is needed to keep the motor from beating itself while bouncing down the road. because the whole weight of the motor is flopping around on the tilt tube with an...
  2. Scott Danforth

    Old Humminbird Depth Finder Repair

    as far as round dash gauges, any of them.
  3. Scott Danforth

    Old Humminbird Depth Finder Repair

    Your wasting your time on any electronics older than 5 years
  4. Scott Danforth

    1998 Bravo 7.4 Non-Magnum - Have Ruined 3 Impellers w/o ever putting the boat on the water...

    If you had a proper pump, that 500 gallon tank would only last a few minutes. No way that RV pump has enough pressure or flow. You need 15 gpm at 60+ PSI. That RV pump is 3 gpm at 0 psi and 0.5 gpm at 50 psi. You would need a 2hp gas powered pump
  5. Scott Danforth

    Power steering troubles

    3/8 inverted flare (5/8-11 threads on the inverted flate tube nut) Pump pressure is between 900 psi and 1800 psi depending on PRV
  6. Scott Danforth

    1990 mercruiser 3.0 harmonic balancer coming off

    Replace it
  7. Scott Danforth

    1998 Bravo 7.4 Non-Magnum - Have Ruined 3 Impellers w/o ever putting the boat on the water...

    And the hose is on full? Hose is 5/8 or larger?
  8. Scott Danforth

    3.0gs Seized P/S pump

    Take the hose to your local hydraulic shop
  9. Scott Danforth

    Stingray 225LR stalling out

    What RPM? What motor?
  10. Scott Danforth

    Volvo exhaust bellow blew

    Volvos do not have shutters However, did you use volvo bellows or cheap aftermarket bellows
  11. Scott Danforth

    1998 Bravo 7.4 Non-Magnum - Have Ruined 3 Impellers w/o ever putting the boat on the water...

    Are you using muffs and good water pressure on a hose or are you attempting to suck water from a bucket?
  12. Scott Danforth

    Mercuiser 180 temperature issue

    Start with the raw water impeller. Do you have the updated heat exchangers? Cleaning the heat exchangers is a yearly maintenance item like pulling the drives and checking alignment
  13. Scott Danforth

    3.0gs Seized P/S pump

    End at the actuator is different
  14. Scott Danforth

    Electric fuel pump

    why> a mechanical fuel pump is $50 and will last 50 years a marine rated electric fuel pump is $85, the required oil pressure switch and relay to wire it properly is another $15 and it will last only 5-7 years (10-15 if you are lucky)
  15. Scott Danforth

    2021 Nascar - Road America - Race 20

    sit at the bottom of turn 5 and watch the roundy round guys crash as they try to hit that 90 degree turn, usually if they make that, they over-compensate going into 6-7. the carousel is another good place to sit and watch carnage.
  16. Scott Danforth

    1988 4.3 OMC Cobra guidance

    blown head gasket and the start of a fire-slotted block you need to clean the deck, and with a very very very accurate straight edge, check the deck between the bores. if you see light under the straight edge, you may need to get the deck fly-cut.
  17. Scott Danforth

    1953 Chris Craft - need title

    depends on the state
  18. Scott Danforth

    1953 Chris Craft - need title

    welcome aboard reach out to the prior owner and check with your local registration office (DNR/tax collector/etc.) in the location where you are at.
  19. Scott Danforth

    3.0gs Seized P/S pump

    just google saginaw power steering pump. your local napa will have one for $50 without the reservoir. a rebuild kit is $14. you will need to use your reservoir. if you buy it from a volvo marine dealer its like $600 (yes, it is seriously marked up that much_ for the impeller, I normally use...
  20. Scott Danforth

    Making a Fibreglass Tub

    no way to use a family van for painting and not mess up the carpets. I would suggest either get a hitch carrier and keep all paint supplies outside the vehicle in a tub. or get a separate vehicle to use as a painters work van.
Top