Search results

  1. alldodge

    Bennett trim tabs

    Should be easy if your talking about these https://bennetttrimtabs.com/product/integrated-helm-control-hydraulic/
  2. alldodge

    M9540 24 speed parking brake

    Well got the tractor back and bill wasn't as bad as initially thought, almost $3800 with tax. Now to see if my attorney can nudge the guy
  3. alldodge

    Having Hot Start issues

    Yes
  4. alldodge

    Having Hot Start issues

    The relay is not your problem The relay can be purchased at most any local auto parts store. Just lay it on the counter in front of a gray haired man/women and they can get you one. To see if it is the relay, use a voltmeter and measure any injector. If you have 12V on them with key ON the...
  5. alldodge

    pop ups...

    I don't see them and I'm using Firefox
  6. alldodge

    When boating, always ___________________

    Same here, just mentioning manufactures are installing on larger boats. I have a 28' even though hull is 25.6 and law states 25' or more
  7. alldodge

    daily music fix

    Bruce
  8. alldodge

    When boating, always ___________________

    Not required but they have kill switches on 30 footers with high sides. Not that anyone I know of uses them, but maybe they should think about it
  9. alldodge

    Boats from work.

    That is a mess
  10. alldodge

    Prop Walk, need a possible solution.

    Does the new and old motor have the same length shaft? Is the Cav plate and prop below the keel?
  11. alldodge

    I/O (Sterndrive) Conversion to Outboards

    Map isn't very accurate, shows I got less than an inch, and got at least 6 and not counting the ice which packed it down
  12. alldodge

    I/O (Sterndrive) Conversion to Outboards

    Power came back on around 6PM
  13. alldodge

    I/O (Sterndrive) Conversion to Outboards

    My heat source for the evening
  14. alldodge

    Having Hot Start issues

    No look again
  15. alldodge

    I/O (Sterndrive) Conversion to Outboards

    Power Went out about 6 hours ago. Fired up the Gen and it's running good, but ....... no output. Last time I ran it some 4 yr it did fine. Put meter on and see 128V but only for a second. So propane logs in basement is good there. Up another set of logs with blower. Using a UPS and 2 marine...
  16. alldodge

    Having Hot Start issues

    No relays on injectors 12V is applied to one side when key is turned ON Other side of injector goes to ECM and it applies a ground when to turn it ON
  17. alldodge

    Maybe my turn for new boat time

    Had my fresh water cruiser moored every season for several years. Bottom got really bad looking and power washing wouldn't clean it up. So painted it with ablative paint. Every so many years had to sand and repaint. So had the bottom paint removed and I repainted with epoxy. Bought a lift and...
  18. alldodge

    Having Hot Start issues

    Search noid light and it will come up It's an LED which provides a light to advise if the injector is firing. Can also be done with a voltmeter if motor is off but will not work when running. You have a motor which in most all cases we will not be able to determine faults without something that...
  19. alldodge

    Maybe my turn for new boat time

    Dealer used a rattle can to repaint the gear case, and paint surface is a bit rough. So my guess is build up will happen much faster on it. Other than that it's back in the barn just before snow starts $100 parts and $200 labor to change water pump and gear lube in other lower
  20. alldodge

    Bravo 1 Question?

    No, all Bravo's even XR, are both so far as rotation. The determination is done by how the throttle control is connected. Starboard side moves cable out for forward and in for reverse Port side moves cable in for forward and out for reverse. No need to keep track of which drive is used where...
Top