Search results

  1. flyingscott

    1983 25 hp XD Merc

    #34 it is literally called a headless screw. It Has a slot in it to adjust
  2. flyingscott

    1970 20hp johnson Ran Hot

    they can if you can find the parts for them
  3. flyingscott

    1983 25 hp XD Merc

    the small screw with no head
  4. flyingscott

    1983 25 hp XD Merc

    Nothing special about an XD. Need serial # and is this a tiller or remote model
  5. flyingscott

    Mariner 90, Lost spark

    Have you checked the ignition switch?
  6. flyingscott

    1954 10 hp johnson carb issue

    Check the Reed valves
  7. flyingscott

    '00 Mercury 90hp, oil injection still works, time to replace it with premix or replace worn parts?

    I agree the 3 and 4 cylinder rarely fail. the V6s that's a different issue. I have a 75 and 90 hp I am rebuilding and they will get their oil injection put back on.
  8. flyingscott

    9.9hp water in crankcase oil

    That's a 4 strk thing it actually has a name, it's called making oil. If the thermostat is bad the motor runs cold and produces condensate, which then ends up in the oil.
  9. flyingscott

    9.9hp water in crankcase oil

    Bad thermostat
  10. flyingscott

    '00 Mercury 90hp, oil injection still works, time to replace it with premix or replace worn parts?

    Seriously? The plastic drive gear is prone to failure on the V6s. Especially after an overheat.
  11. flyingscott

    1966 Johnson 20hp won’t idle and makes a stutter sound

    that looks like a miss either carb or electrical. run a timing light on it
  12. flyingscott

    2003 Johnson 90hp fuel pump

    When VROs go bad they tend to over oil the motor. Go premix or take the pump apart.
  13. flyingscott

    94 28hp SPL Johnson

    Normal. No cover or air box on those
  14. flyingscott

    Have you had any dealings with the Yamaha website ? "https://yamaha2strokeoutboards.com/"

    buyer beware
  15. flyingscott

    1976 Johnson 9.9 won’t “rev” when in the lake.

    Thats the wrong ignition system. OP has the low tension magneto with external coils
  16. flyingscott

    Impeller replaced

    Are you sure the pee hole is not connected to the thermostats? Some models of Merc Require the thermostats to open to pee. Also on muffs should take far less than 90 seconds to bleed out the air.
  17. flyingscott

    Mercury 25xd no start

    Is the high idle rod in place? Is the primer assembly correct? Is the base gasket on right?
  18. flyingscott

    Carb for 1985 Mercury 25XD

    The manual choke on that motor works better than the electric choke does.
  19. flyingscott

    Carb for 1985 Mercury 25XD

    The way that Choke works is you pushing the key and it closes the little port. When you release the key it uncovers the port. Your primer mech would have had the square know. The newer style has a round knob.
  20. flyingscott

    150 hp lower unit replacement

    Have you looked at the gears? Are they bad? If the gears are good maybe just needs bearings.
Top