Search results

  1. Faztbullet

    1992 Evinrude 150hp EXEN will not run correctly

    There is a difference in manufacturing and assembling. You can take pieces from anywhere and assemble in your kitchen and states item was made in USA.
  2. Faztbullet

    intermittent tach and not charging 1994 ocean pro 150

    It is a water cooled rect/reg. A weak impeller will not fill the water passge up internally in the block causing it to overheat and fail. They need a impeller every 2 years no matter how good it pee's
  3. Faztbullet

    Help with engine identification please.

    Its a 1987 powerhead on a new style 25" midsection. Wire to Faststart and temp on port head wires cut
  4. Faztbullet

    1992 Evinrude 150hp EXEN will not run correctly

    Cause they are Chineseem pumps and OEM parts wont fit.
  5. Faztbullet

    1990-1995 era 3 cylinder charging capability?

    It only got a 12 amp charging system and this is at WOT. You could only use a single bank model (MK-1) and charge 1 battery. The charger will not divert any voltage to additional battery's until main battery reaches 13.6V. I sell the Dual Pro series to my Bass customers as the bigger engine are...
  6. Faztbullet

    Picture of my prop - what’s going on here?

    Wrong thrust washer and incorrect torque will cause this as stated earlier
  7. Faztbullet

    Prop Id help-what is this?

    Old Chris Craft or Ski Nautique bronze prop...bore looks to be 1"...
  8. Faztbullet

    Yamaha F60TLRB 2003 4 stoke - running wonky

    Carb sync and link most important on 4S as is idle mixture. If engine has been setting a long period it may have ethanol damage in carbs
  9. Faztbullet

    Will Replacing Rings Increase Compression >105PSI?

    It needs inspected ..as in cylinders miked, most likely bored to .020 and a set of 60HP carbs installed...Vola!! more compression and 10Hp
  10. Faztbullet

    Fuel restriction alarm

    I wouldn't adjust the contacts as they are likely set to a certain height and awaits the pins movement. Dug this up as explains oil circuit... https://www.thehulltruth.com/boating-forum/851310-just-little-insight-into-oil-side-vro2-oms.html
  11. Faztbullet

    1992 Evinrude 150hp EXEN will not run correctly

    Sync and link correct?
  12. Faztbullet

    Reed Valves

    I cant remember all the details on why but it had to do with the bleed restrictors and flow.
  13. Faztbullet

    Reed Valves

    Same CFM goes to each cylinder as reed block only feeds needed cylinder in firing order on the up stroke.
  14. Faztbullet

    Reed Valves

    The 10 side goes up towards flywheel
  15. Faztbullet

    e150FPXEEN SER:G04677162

    This is a Ficht and doesn't have Quickstart. They are known on the 60°motors to break the TPS if cables are not set up correctly, especially with a hot foot.
  16. Faztbullet

    40hp mercury exhaust leak

    Coming out from motor mount area?
  17. Faztbullet

    e150FPXEEN SER:G04677162

    Dont do this!!!! Start engine, wait till it warms up and comes out of Quickstart, then you can rev it a lil but not over 2K
  18. Faztbullet

    Setting gear lash/engagement 2000 johnson 2 str 40hp 2 cyl

    Red Rhino/OBR same company...parts are fine
  19. Faztbullet

    Setting gear lash/engagement 2000 johnson 2 str 40hp 2 cyl

    Get yourself a OEM manual...it will walk you thru it step by step
  20. Faztbullet

    Lower bearing end float and bearing shim

    Top piston damage on these our usually water cooling related or ignition problem. Make sure you replace impeller and switchbox (OEM)
Top