Search results

  1. S

    Getting no beep when turning the key

    Battery, corroded wire or something along those lines is where I would start. Check voltage at starter solenoid from battery and then the other side of the solenoid while turning the key.
  2. S

    oil leaking from DT 40

    That is a 10 year old thread so don't expect an answer. Post a new thread with your current problems and you should get some responses.
  3. S

    1990-1995 era 3 cylinder charging capability?

    Well it says it can....
  4. S

    1994 40hp Johnson run

    I call that a Tesla coil!
  5. S

    1991 25hp evinrude starting issues

    Well your in it now. Go online and seek out testing all those components and then you should have this tool to put everything back on so they are set right in relation to the flywheel. Look and see if any of those components have wear marks where they might have rubbed on the flywheel.
  6. S

    1991 25hp evinrude starting issues

    Yes, thank you.
  7. S

    1991 25hp evinrude starting issues

    Funny! My uncle always said, "the woman's place is in the home, right after she gets off work?" God rest his sole.
  8. S

    1991 25hp evinrude starting issues

    Take picture of under the flywheel. Plug wires looks my good means nothing. Try to eliminate one thing at a time correctly.
  9. S

    1991 25hp evinrude starting issues

    The wire could be the problem.
  10. S

    1991 25hp evinrude starting issues

    Check for damaged wires coming from under the flywheel....could have a short When you swapped coils did you also move the coil wire?
  11. S

    1991 25hp evinrude starting issues

    Try the coil, then try pumping the primer ball when it's starts to die.....different tank, then report back. You might possibly try this.
  12. S

    1991 25hp evinrude starting issues

    Try switching the coils and see if the problem follows the coil....if it does you know you have a bad coil. If it doesn't follow... it could be your power pack.
  13. S

    1991 25hp evinrude starting issues

    Which would be part number 20 and 22. Also I can't tell, is part number 1 in?
  14. S

    1991 25hp evinrude starting issues

    Frustrating I'm sure. Have you been under the flywheel? If so was it clean? Did you replace anything and if so we're those components aligned properly. Could be one cylinder but it seemed like it leaned out and quit at the end of your video. Have you tried a portable gas tank....wondering if...
  15. S

    1991 25hp evinrude starting issues

    Also, have you been under the flywheel at all?
  16. S

    1991 25hp evinrude starting issues

    Okay, and your letting it warm up before you play around with the low speed idle jet I assume. Other than components like reed valves and such it sounds fuel related. When you rebuilt the carb how bad was it inside? Did you clean every passage ways completely? In the carb throat at the top...
  17. S

    1991 25hp evinrude starting issues

    So what is the current exact issue? Will it start and idle fine? Put it in gear it dies? On the water or on muffs? Describe in detail and post a YouTube video.
  18. S

    2007 Mercury 90ELPT 4S cuts off shifting into Neutral

    Only thing I can think of is the nutruel locator switch in the control box is malfunctioning.
  19. S

    Difference between 1986 50hp and 60 hp 2 stroke carburetor?

    I didn't see a 60 by the way, 70 was the next one up.
  20. S

    Difference between 1986 50hp and 60 hp 2 stroke carburetor?

    Jets seem attainable but can't you use your old jets or are your carbs missing?
Top