Search results

  1. Scott Danforth

    Transom ski hook to ski rope

    yep. Note, that hook is only rated to pull a skier ( 400# rating), not a tube (2400# rating)
  2. Scott Danforth

    Wiped cam lobe mechanical fuel pump

    Relay coil is not voltage direction sensitive.
  3. Scott Danforth

    Wiped cam lobe mechanical fuel pump

    No, that is the crank signal yo the S terminal. You want to wire to the R terminal
  4. Scott Danforth

    Cobra outdrive

    Pull the drive. That should be done annually
  5. Scott Danforth

    Wiped cam lobe mechanical fuel pump

    The terminals on both the relay and the switch should be labeled Oil pressure gauges go to a gauge sender Pics don't currently work
  6. Scott Danforth

    Stuck In Gear

    Shift interrupt switch not working. Most likely need a new lower shift cable
  7. Scott Danforth

    Wiped cam lobe mechanical fuel pump

    Yes
  8. Scott Danforth

    OMC I/O first test drive, need some part names.

    Did you do all the drive service? Raw water impeller? Ball gears?
  9. Scott Danforth

    Mercruiser 3.7l voltage regulator smoking

    Agreed... Most likely the overheating baked the regulator The 470 can not have even a 10 degree overheat If you maxed the temp gauge, most likely you will find other things baked
  10. Scott Danforth

    Mirrocraft 12’

    Doubt you will get an answer. The company name was sold about 4 times since 1966
  11. Scott Danforth

    Can you paint an outboard cowling with automotive spray paint?

    The purple harbor freight gun is good for about 2-3 cleanings in clear, about another 2-3 cleanings on color, and about 5-10 cleanings on primer If you use them for varnish, they will last about 12-15 cleanings Don't soak them in acetone, the plastic knobs melt
  12. Scott Danforth

    1995 OMC Cobra v-6 will not rev out under load

    Look at the fuel system Look to make sure ethe flappers are not plugging the exhaust Motor will rev running on only 2 cylinders
  13. Scott Danforth

    Mirrocraft 12’

    The factory tag would look similar to this https://garzonstudio.com/media/catalog/product/cache/59459228875d6cf9fada9a2c32eb4717/w/-/w-mirro-craft-14-boat-capacity-decal-1960s-plate-sticker.png
  14. Scott Danforth

    Mirrocraft 12’

    It could be a state assigned HIN from a registration in the past 50 years. However a 1966 mirro craft would have a serial number tag from the factory HINs were not made until 1972
  15. Scott Danforth

    Mirrocraft 12’

    Boat earlier than 1972 have serial numbers which would be on the tag They do not have HINs on the hull
  16. Scott Danforth

    Rustoleum or not

    I would add a hardener to it to make it wear a bit better
  17. Scott Danforth

    Bathroom (head) caulk

    Life caulk come in various colors
  18. Scott Danforth

    Mercruiser 3.0 LX spark plug failure

    Improperly tight plug will overheat as it can't transfer heat to the head. This results in the ceramic heat fracturing and blowing out
  19. Scott Danforth

    1984 stingray svb cap removal

    There is sealant between the cap and hull. I used a linoleum knife on sealant when I pull a cap
  20. Scott Danforth

    Manual jack plate starting height

    Tunnel cats will float in about 6-8" of water You power the prop down with the jack plate on hole shot
Top