Search results

  1. Scott Danforth

    Water Diagram

    The sea swirl squirt was a jet boat in the 90s (1994-1997) with a V4 OMC power head and a jet pump
  2. Scott Danforth

    Electrical Diagram

    Never existed. Look at the factory service manual for the outbound. It will have motor and control related wiring schematic The rest of the boat, you will need to trace wiring
  3. Scott Danforth

    Dock question: how do these sections hook together?

    Its a roll out dock. You most likely pull the wheels when you get it where you need Bring the section without the hooks first. Level, set, etc Bring the hooked section up behind it. Lift so the top side of the angled hook hits the bottom side of the deck, and the hook clears the angle...
  4. Scott Danforth

    Dock question: how do these sections hook together?

    I don't think you need to remove the deck
  5. Scott Danforth

    Trim pump not working in down position

    permatex #3 works too, make sure its after the last o-ring
  6. Scott Danforth

    Trim pump not working in down position

    the AQ 290 series VP drive has the pins for the rams accessable only when the engine and drive are pulled (almost to the point of removing the transom shield. ) the easiest way to repair them is on the boat.
  7. Scott Danforth

    Trim pump not working in down position

    not needed, in fact it is not recommended. the wiper will remove all grease. the rods get lubricated from the hydraulic oil. the grease will just attract dirt and take out the wiper and seal.
  8. Scott Danforth

    Dock question: how do these sections hook together?

    there should be some hardware that goes thru that hole to keep them together thru the season. I do not miss putting in or taking out docks.
  9. Scott Danforth

    1988 Rogue 2420

    Yesterdays's celebration of another successful celestial star orbit netted a 13 gallon fresh water tank and a transom swim shower.... will go hand in hand with the pump, fill, and a few other bits squirreled away in my parts bins will break away a bit to work on the boat.
  10. Scott Danforth

    Dock question: how do these sections hook together?

    You can see the witness marks where the angled hook bits butted up against the frame. Sort of like a drunk congo line where you have to hold the belt of the guy in front of you
  11. Scott Danforth

    Boat Top W/Windows

    See your local marine upholstery and canvas shop
  12. Scott Danforth

    replacement Chevy engine for volvo penta

    Get the GM or Volvo parts. Not AutoZone.
  13. Scott Danforth

    5.0 MPI Water Pressure Sensor

    Common problem
  14. Scott Danforth

    Coolant Disappearing, need help

    If there is a leak, the motor probably can not make pressure. If it does, then the system is drawing in the raw water vs coolant from the puke tank Have your heat exchanger pressure tested (and repaired if needed)
  15. Scott Danforth

    Thru Hull Fuel Vent Fitting

    should be 5/8" vent fitting (16mm) measure your hose. you most likely will need to either plumb in the P-trap or make sure your new vent has the p-trap.
  16. Scott Danforth

    Anybody have "old" pontoons?

    one of our customers builds tri-toons with 2 450R's on it.....80mph on a pontoon......
  17. Scott Danforth

    84 3.0 Exhaust Riser Gasket Leak

    no, water in the exhaust chamber of the manifold is not normal. yes, water in the water jacket of the manifold is normal leaking gasket could have leaked into exhaust side.
  18. Scott Danforth

    Wiring Diagram

    the engine manual will have controls and gauge wiring. the remainder of the boat should (may not) be to ABYC standards. generic wiring data in the electrical forum
  19. Scott Danforth

    Motor runs but in water dies when throttled

    is this "new" carburetor one of the amazon specials?
  20. Scott Danforth

    Mercruser 470/ 170 compatible parts

    most of those guys are die-hard hot rodders with a garage full of machining equipment.
View older results
Top