Search results

  1. Scott Danforth

    anybody need a good used prop shaft??????????????

    you cant see torque....... er..... nevermind........
  2. Scott Danforth

    Which side to mount trolley motor on??

    Generally, its not on the side with the steering wheel (so you can see straight ahead).
  3. Scott Danforth

    DIY - Canvas Enclosure

    I do need a top and seats redone in the Fiat..... ;D
  4. Scott Danforth

    Wont go past 2500 rpm

    check the neutral safety switch. if the EDM thinks the motor is in neutral, the RPM wont go above a certain RPM check fuel pressure. if you are TBI or MPI, there are different pressures.
  5. Scott Danforth

    454 vibrating and breaking starter bolts

    may have to pull it apart to determine what you have.
  6. Scott Danforth

    Blower Motor Venting Question

    remove the chunk of green plastic that someone added these are your vents
  7. Scott Danforth

    restoring documentation

    Wiring diagram never existed. Look for the generic information in the electrical forum. The wiring colors are an ABYC standard. And the wiring specific to the motor in the motor manual
  8. Scott Danforth

    Re-powering a 1978 21' Starcraft Mariner - Engine Help!

    plenty out there in the 70s and 80s
  9. Scott Danforth

    Water tank fittings

    loctite 565 is what I would use can use 3M 4000 UV here too.
  10. Scott Danforth

    DIY - Canvas Enclosure

    Dont worry, first time it gets wet, then the sun hits it........ it will shrink and you wont be able to snap it again......
  11. Scott Danforth

    DIY How to build an outboard stand with a 275lbs+ rating

    I have two outboards and a trolling motor on a stand built out of 2x4's I did have to go to thru-bolts after the deck screws broke
  12. Scott Danforth

    Folding dock cleats

    I would go with pop-up cleats vs folding. the small folding ones are generally for hanging fenders where the pop-up cleats are load rated.
  13. Scott Danforth

    Re-powering a 1978 21' Starcraft Mariner - Engine Help!

    and the jack plate pushes the motor aft about 4-5" so that really squats the boat. I would stick with a short shaft on the boat.
  14. Scott Danforth

    1987 GM 305 x 2 rebuild questions.

    and if you go vortec (1996+ motors), only the intake manifold must change and you get even more power.
  15. Scott Danforth

    Mercruiser 3.0 Leaking Water On Top of Manifold

    did you probe the drains in #3
  16. Scott Danforth

    Title Issues

    You need to call the local registration office
  17. Scott Danforth

    Mercruiser 3.0 Leaking Water On Top of Manifold

    How did you winterize?
  18. Scott Danforth

    Re-powering a 1978 21' Starcraft Mariner - Engine Help!

    What's wrong with the existing motor? With maintenance it will out last all the new motors
  19. Scott Danforth

    1993 Carver 280 Express listing to port.

    Carvers of that vintage have lots of wood
  20. Scott Danforth

    I just got a 1980 Renken w/OMC stringer

    You were told wrong It didn't show more than 100 because there is no water in the block With cooling water, your exhaust temp is 200f Without cooling water, the exhaust temp is 1100f
Top