Search results

  1. R

    1987 Johnson 140 VRO stalls when i put in gear in the water

    Perhaps look into getting your money back.
  2. R

    1987 Johnson 140 VRO stalls when i put in gear in the water

    Do you have spark on all 4 leads that jumps a gap of 7/16" on a test device, yes or no ?
  3. R

    1970 25hp deceleration after run at WOT

    Water pump impeller ?----Fuel pump diaphragm ?
  4. R

    1987 Johnson 140 VRO stalls when i put in gear in the water

    The 2 steps to start with.-----Compression test.-----Post the values.-----Then a spark check.-----Does spark jump a gap of 7/16" on a test device ?-----How did the motor run for you last season ?-----Is oil injection in service ?----Was it tested for output ?------Or mixing at 50:1 in your tank ?
  5. R

    2010 Evinrude E-Tec 60 HP cold start up issues

    In my opinion it is easy to take the starter apart for inspection / testing.-----Some will just rush out and buy a new one.-----I would like to be sure before I buy new parts.
  6. R

    1989 Evinrude 30 2-stroke losing power at high RPMs

    The issue is not the plugs !----Does spark jump a gap of 7/16" on both leads on a test device ?----Run with a timing light one cylinder at a time.----See how spark behaves at full throttle.-----I am thinking there may be an issue with bottom crankshaft seal.----But I can not see or hear your motor.
  7. R

    J8RESR 8hp Johnson no spark

    Kill switch on the end of the tiller.----Do you have that plastic key in there ??
  8. R

    1989 Evinrude 30 2-stroke losing power at high RPMs

    Have installed a new impeller recently ?----Test run with another tank and hose ?
  9. R

    Cooling diverters

    No diverters in your motor.
  10. R

    1996 Evenrude 90hp

    The 1/4-20NC bolts are 80 INCH LBS.
  11. R

    96 Johnson 150 v6 not idling

    Port side top is #2----The top cylinder ( look carefully ) is #1-----#1 is on the starboard side.
  12. R

    96 Johnson 150 v6 not idling

    Try moving coils.----No money spent and report the results.-----Cylinders are numbered from top ( #1 ) to bottom ( #6 )
  13. R

    96 Johnson 150 v6 not idling

    Running on 4 of 6 cylinders would explain your issue.
  14. R

    1978 Evinrude 150

    Many different opinions on compression.-----I would be concerned with those numbers on my gauges.----Then again it may have a ---" low compression kit "---Installed on it.
  15. R

    1978 Evinrude 150

    Those values appear low to me.----Might be the gauge.
  16. R

    1962 Mercury kiekhaefer 450 45 hp telltale

    ???-----Those are drain holes should there be a leak in the cowling.----Either from rain or a gasket leak.----Drive by your local shop and ask them to show where a tell tale would be.
  17. R

    anchors

    Anchors are hard to buy when you need a bigger one in tough conditions.----Looks very similar to a danforth style.
  18. R

    15hp Evinrude acceleration issues

    A 1974 model or ???-----Pressure test the gearcase to find the leak.-----A complete seal kit is a good idea.----Including the shift rod o-ring.-----Check shift linkages for poor assembly / adjustment.-----Perhaps another prop.
  19. R

    Can a 1976 15HP carb fit on a 1990 9.9HP Evinrude ?

    They changed in 1993 model year !!-----The motor in the picture is a 1998 as per decals.
  20. R

    1987 GAMEFISHER 15 HP

    Well it appears that the Force motors used a 10 spline prop.-----Some will argue.----A local good Mercury dealer that cares about customers will help you.-----Sadly many do not know older motors or care , unless you come in to spend $10,000 for a motor.
Top