Search results

  1. alldodge

    No crank no start

    With it not cranking over, need to start at the key as Bondo mentioned. Need a voltmeter to trace the voltages. Might be the key or slave solenoid
  2. alldodge

    Mercruiser 7.4 top end issues

    MEFI 3 is better then the 1 and 2 by far, but still does not go very far to help. Is starting to look like a ground or corrosion issue
  3. alldodge

    Bilge Pump discussions

    I'm on my 4th complete shower bilge, have 3 sitting on the shelf. Last one bought had the Sarhara 500S pump. Looked like a good self contained pump with built in float switch. This is the first year for this shower bilge. During winterization I did the usual and soaked up all liquid and put...
  4. alldodge

    OMC 5.7 L with EST and without ESA

    Your file in your post above has an error, unable to see The EST distributor uses 12V to interrupt the distributor on the right hand connector. The interrupt switch needs to be changed from applying a ground to have it apply 12V This is a Merc 4cyl but works the same, and this shows how to set...
  5. alldodge

    Mercruiser 7.4 top end issues

    Pics
  6. alldodge

    3.0l looses power

    Fuel pressure should be between 3 to 7 psi from idle to WOT Get some rubber fuel line and barbed fittings to make a Tee fitting to measure. Can also get Merc fitting 91-18078
  7. alldodge

    97 volvo penta 4.3 gl multiple problems

    Points 85 and 86 go across the coil of the relay, and 86 goes is ground. When the motor is cranking 12V should pass thru the Yel/Red wire, thru the diode to pin 85. When the motor is running 12V comes from the alternator green wire, thru another diode to pin 85. When ignition is turned to ON...
  8. alldodge

    2000 volvo 5.7 gx steering hard to the right

    Steering to the right would be easier because the prop is spinning that direction, and hard to left because your pulling against the prop. Is the slot straight up/down as in pic "d" with wrench on it
  9. alldodge

    Thunder Bolt ignition sensor replacement gone bad

    There is a fuse on top the starter which feeds power to the motor and alternator, its 90 amps But if it blows, normally there is no power for anything. Why are you running power from the battery to the slave?
  10. alldodge

    Idiot needs help!!! 2001 5.7 GXI-B TBI

    This is what I have
  11. alldodge

    2005 350 mag (5.7) smartcraft faults Water pressure + fuel level sender

    This changes everything :facepalm: my bad, I was off in the wrong arena Smartcraft uses a CAN bus, but .... that gauge will connect to the data link. The kit should come with instructions, but it basically gets daisy chained form the harness of other gauge. You do have to install the sensor...
  12. alldodge

    Idiot needs help!!! 2001 5.7 GXI-B TBI

    Need to measure your fuel pressure. Place it inline at the TB
  13. alldodge

    Bravo One OD

    Correct, it happens just behind the intake water hose where it attaches to the transom assembly. Not a hard fix, and is usually done when replacing bellows. My 95 Rinker had no signs of it by installed the new design anyway when replacing bellows
  14. alldodge

    94 mercruiser 350 low idle after thermostat change

    Need part number 91806901 or similar. Its a GM TBI test fitting
  15. alldodge

    350 Mag fuel pump cuts off intermittently

    If the plastic block (pis are always best) looked like this, Then its a 90 amp fuse used to portect the engine harness if the alternator shorts out. The fuse is inside the block
  16. alldodge

    Low priority but

    Can we happen to make this little (very little) close mark a tad larger? Open the pic, look and try to close it using a touch pad is real hard, even a mouse is touchy. Sometimes I just give up and arrow back and then find the thread again Low priority but would sure like it if it was a tad...
  17. alldodge

    350 Mag fuel pump cuts off intermittently

    I'm thinking a bad connection, either on the Green wire between Pin A19 and Relay pin 86, or the fuel pump ground (not shown in pic). Could also be a bad connection on the hot side, but would start with ground on fuel pump first
  18. alldodge

    Lost gas cap

    Could use a measurement across the opening, but it looks like the standard 1 1/4 inch fill cap. Perko makes one, and Seachoice has a chrome replacement. Iboats has the whole fitting, but nothing except yam for cap, found the seachoice cap at walmart
  19. alldodge

    1988 Mercruiser 165 4 cyl wont start

    In that case the idle jets are probably clogged up, so it needs to be taken apart and cleaned. Need some fine wire and feed it thru the idle circuits
  20. alldodge

    6.2 mercruiser no power under load

    Guess they need to change their manual 31 (5.0, 5.7, 6.2) because I'm seeing 43 psi at 1800 rpm, the V6 manual 32 shows the same
Top