Search results

  1. alldodge

    mercruiser 260 riser gasket recommendations

    Re: mercruiser 260 riser gasket recommendations Not knowing what your serial number is I'm working from a 1978-82 260. That would be for the most part yes These 3 pics should show what the installation is. There are two exhaust gaskets and one exhaust plate sandwiched between them
  2. alldodge

    Connecting alt from 2nd engine to house bank. Where should sense wire go?

    Re: Connecting alt from 2nd engine to house bank. Where should sense wire go? Hulakai - I seem to have given you some bad advise on my first drawing. After thinging about it and seeing your new post I have seen my error. You first mentione that your wiring was fried so I didn't know what I...
  3. alldodge

    Weird Thunderbolt V problem, driving me mad

    Re: Weird Thunderbolt V problem, driving me mad The file attached is how a 3 bank battery would be setup. You would only use one switch to combine the house and start batteries. If you keep it with 2-banks keep the Generator with the start batteries. If an isolator is used it would be run...
  4. alldodge

    5KW kohler

    Boat has 500 hours genset has lee than 50 hours. The genset hardley gets used as seen. This year the gen will not start. The fuel pump pumps fine but that is with me applying power to it. All the sensors I believe go to ground when they sense a fault. Impeller has been changed twice but...
  5. alldodge

    Moving Fuel Filter (Aluminum Headers)

    IMCO makes a bracket to move the oil lube container and fuel filter and I?m sure works very well. Never found anything from IMCO which isn?t top notch. I decided to try my luck at just moving the fuel filter. This install moves the fuel filter up and forward to clear the exhaust manifold and...
  6. alldodge

    Front PS pump bracket

    Installed some new aluminum headers on my 502. The header manifold is slightly wider then the original cast iron and caused an interference with the power steering (PS) pump. Found an extension bracket from IMCO which extended the PS pump up and out about an inch to clear. The front brace...
  7. alldodge

    502 Lost Power acting like V6

    Quick history: 502 MPI wich has the VST canister pump. Took the VST apart last winter and cleaned the filter. Running fine this spring until it got real hot then I had issue with vapor lock. Probably caused the vapor lock my self due to filling up last winter with winter mix and ethanol...
  8. alldodge

    VDO Vanguard Gages

    The fuel gauge on my 95 Formula keeps hanging. I start it up and bang on the gauge for a bit to see if it moves one way or another. I've never run out of fuell just appears the gauge is hanging inside. It currently mounts from the back and the hole is less than 2 inch, so if I'm having trouble...
  9. alldodge

    27PC water tank repair

    1994 27PC and the water tank is leaking into the cabin bilge. Just started this season and leaks down to about an inch from the bottom. Called tech support and they informed me that I would have to cut through the aft cabin floor and pull it out from there. After pulling the cabin apart I'm...
  10. alldodge

    502 VST Once over/Repair

    So far my cruiser is doing OK but I want to give the Vapor Seperator Tank (VST) the once over this winter. Accomplished several search's looking for information but came up no where except for the same parts list. I have down loaded the parts list and diagram but there are ten kits listed...
View older results
Top