Search results

  1. 90stingray

    Is this engine mount correct? Have pic.

    I bought this boat about 3 years ago... had everything check out when i bought it. Its always seemed like the engine vibrates the boat when running, more than i thought it should. Passed it off as a 20 year old boat. This spring I have checked bellows, changed gimbal bearing, etc. I checked...
  2. 90stingray

    Aftermarket trim pump assy... has anyone bought one before?

    My trim pump has been getting slower and slower going up each year. It is also getting louder and louder. Figured its time for a new one... but dang... they are expensive! Found a few assys on ebay for like $200. Just wondered if anyone has tried the cheap-o pump assys and what the outcome...
  3. 90stingray

    Exhaust tube vs. exhaust bellows

    Wondering if anyone has run the exhaust tube instead of the exhaust bellows? And what the pros and cons of each would be. Is it too noisy? I have a 4.3 v6 and alpha one. Bellows are getting a little cracked out... just trying to plan ahead when it comes time to change. Let me know what you...
  4. 90stingray

    Alpha one gen one shifting

    Changed impeller and reassembled drive last winter but never started her. Shifts good into fwd but if I go to reverse it clicks like not fully engaged. Did I get the shifter paw one spline off when reassembling? Would it be better to open drive back up and move it one spline? Or should i...
  5. 90stingray

    Gimbal bearing change... double check

    Hey, i have a 90 4.3 V6 w/ alpha one. While engine is running there is a noticable growling grumbling noise coming from transom area. Gimbal bearing is suspect. I pulled the drive and sure enough feels rough when you put a little pressure to the sides while turning it. U joints feel good...
  6. 90stingray

    Alpha One Gen One U Joints: Part number help

    Hey i looked at the sticky in the adults only section under u joint part number and there were only part numbers for the gen 2 drive. I would like a spicer part number or something i can get at a parts store on the cheap. Have an alpha one gen one, s/n OD462242. 1.84 Ratio behind a 4.3 V6...
  7. 90stingray

    Bow safety chain or strap?

    When should a safety chain be used and when should a strap be used? Both are in conjuction with the winch strap of course. My trailer came with a loop welded to the winch stand... i am assuming for a strap. But i drilled a hole in below the winch and mounted a wratcheting nylon webbed cargo...
  8. 90stingray

    How do i buy a winterized boat?

    What's everyones thoughts about looking to buy a winterized boat. Its a 1991 Larson 20 footer. 350 mercruiser and alpha one. At a minimum I would like to start the engine... but she's all drained out of water. And the temps here are high of 35. Whats the normal procedure one should take? Thanks.
  9. 90stingray

    4.3 Mercruiser backfires @ 4000rpm and above

    Hey all! Been a long time follower of this site... but just joined today :) Got a 17.5' 1990 Stingray 4.3 w/ alpha one. Bought her early last year. It's always had a surge and backfire at any rpm above 4000. I have done new plugs, wires, cap, rotor, coil, fuel pump, new fuel lines, added...
View older results
Top