Search results

  1. alldodge

    Ideas for planters/raised beds?

    I know folks that do no till and have great growing every year. 30 inch wide for plants and 18 inch wide for walk way It takes a couple years to get it working great, but after that all good
  2. alldodge

    Mercruiser 350 MAG MPI

    Your ECM post 4 shows the date of 2005 Being a 2005 your max WOT RPM is 4400-4800 per manual 31
  3. alldodge

    Merc 250 Verado Fuel increase

    I know what your talking about. Looked at these when running with the Rev 4 props with my buddy watching as RPMs increased to WOT. Will compare with the new props Wanted to take the boat out today and fill the tank with readings, but winds were up around 20 mph so if things work out I'll try...
  4. alldodge

    Metal O-Ring appeared on alignment tool

    That's the inner spine on a lip type seal. Probably from the grease seal behind the gimbal bearing Edit Bondo was quicker
  5. alldodge

    Ideas for planters/raised beds?

    TSC and rual king have 40 gal tanks for 179
  6. alldodge

    why is there oil in my bellows but pressure test holds 15psi overnight

    Try putting 5 to 7 psi in and rotate the drive shaft. Also try to move it up/down/side to side to see if you loose pressure. With a lip seal, the more pressure is applied the tighter the seal is forced against the shaft If all that works without leaks, try a vacuum at 3-5 inHg
  7. alldodge

    I/O (Sterndrive) Conversion to Outboards

    Forget the exact name of the product but something like Bondarite and used to adhere transom wood to hull
  8. alldodge

    Pushing Run-Flat tires to the limit

    Most are running low on blinker fluid
  9. alldodge

    No dipstick on 1989 era 3.0L?

    10W40 diesel oil
  10. alldodge

    Alternator and fuel pump on Volvo Penta 3.0 GLP-D

    There is a bad connection somewhere My thought is that the wire would be close to the end of the tubing. Try looking at the other end of tubing and see how many wires are inside
  11. alldodge

    Just thought I'd share a nice photo.

    They are Gold Finch and redid vid to remove my name
  12. alldodge

    Just thought I'd share a nice photo.

  13. alldodge

    Alternator and fuel pump on Volvo Penta 3.0 GLP-D

    The left side (12V from Bat) wire is what should go to the choke coil on carb Peal the insulation tubing back from wire on the right to find the other wire that should be connected to the other
  14. alldodge

    Alternator and fuel pump on Volvo Penta 3.0 GLP-D

    Your motor does not have a mechanical fuel pump You have a break in a connection, don't know if that is inside the ALT or a wire. What your doing is back feeding the circuit The relay wasn't working until it was back feed Remember you have 2 diodes feeding the fuel pump relay, find them and...
  15. alldodge

    Merc 250 Verado Fuel increase

    Replaced the plugs and didn't notice any vibrations but also didn't take it out Called dealer and they agreed to take care of the overspray but I have to take it to them. I said thanks for admitting they caused it, but no thanks. Dealers is 1.5 hours away and who knows how long they will have...
  16. alldodge

    Honda 225hp

    Should not be an issue
  17. alldodge

    Alternator and fuel pump on Volvo Penta 3.0 GLP-D

    @kwanza1 noticed in your first post you mentioned that you were unable to get into your original account. Guessing it was @Kwanza so maybe @tpenfield can assist I don't have a wiring diagram for your exact model but do have one for GL-E which also uses the EST ignition. With the ALT not working...
  18. alldodge

    I/O (Sterndrive) Conversion to Outboards

    Since there are 4 flat prior to radius, start with a circle saw with carbide blade
  19. alldodge

    What kind of dashcams is everyone using?

    Yes, the the socket stays hot, unplug it
  20. alldodge

    1981 MC-1 driveshaft reinstall into upper housing- any tricks to this?

    Take just the race and see if it fits, hope the housing isn't warped
Top