Search results

  1. S

    Mercury 25 hp motor removal and replacement

    I have a 1985 Sea Nymph 14R aluminum V-hull boat with a 1987 Mercury 25 hp motor on it. I need to find a way to remove and replace the motor so I can work on the bunk boards. I have never done this before and need suggestions to do it safely and insure the motor is back exactly where it needs to...
  2. S

    1985 Sea Nymph 14 R V hull boat bunk adjustment questions

    I have an old 1985 Sea Nymph 14 R aluminum v-hull style boat on what must be an old piece meal trailer. There are 3 fixed position center rollers and two approximately 6 1/2 foot long bunk boards. They aren't really angled as I think they should be to at least approximate the angle of the hull...
  3. S

    Spark plug question for 1987 Mercury 25 hp 2 stroke

    Hopefully this is the right category for asking this question and hopefully someone may know the answer as obvious as it may seem to others with far more knowledge and experience in this area then I have. The PDF user manual I have for this motor cals for either NGKB7HS, Champion L82 or AC S41F...
  4. S

    1987 Mercury 25 hp run/stop switch & plug wires wiring questions

    I had recently purchased this 1985 Sea Nymph boat with the above mentioned 1987 25 hp Mercury outboard. I was having trouble with the start/Off switch not shutting the motor off. Shortly after I discovered what I thought was just a loose black wire seemingly under a silver plate with 4 phillips...
  5. S

    How to measure for a level floor in V-hull aluminum boat

    Re: How to measure for a level floor in V-hull aluminum boat Hope I am doing this reply right. The info tag on the boat says 830 lbs. total with boat, motor, people and gear. It specifies a rating of 25hp which is what it has on it now. A mercury 25 hp/electric or pull start. There will not...
  6. S

    How to measure for a level floor in V-hull aluminum boat

    I recently purchased a 1985 Sea Nymph 14R Big Water V-hull aluminum boat. It had some decking/flooring in it but most was rotted out underneath. There is some aluminum angle fastened with rivets to the factory bench seats. However I do not believe they are level. I am trying to figure out how to...
View older results
Top