Search results

  1. T

    Just can not figure it out

    Hi I have a question Did the motor ever crank good after sitting for awhile?
  2. T

    1984 mercury bleed lines

    Thanks Just like johnson, evinrude. I was not sure what Mercury used . I thought it would be the same but was not sure. I do need to check the reeds but i need gaskets and have not found one yet that was for verticle reeds on the normal purchase sites. I did not want to mention them since i dont...
  3. T

    1984 mercury bleed lines

    Hi I need to correct something. You were completely Right they can be blocked off with no problem. I ran my motor in a tub this morning by doing this when i accelerated it i heard a cough and it blew the rubber hose off of #2 I put it back on gas it gas #1 blew off then again and #5 blew off. I...
  4. T

    1984 mercury bleed lines

    Hi I was using the engineering term for that kind of ring, not the book or part ordering name of a crankshaft compression ring. I have never torn down a mercury but it still has to seal off each combustion cylinder seperately like any other multi cylinder two stroke engine. I have seen a few...
  5. T

    1984 mercury bleed lines

    Hi Dont plug the bleed holes if you plan to rev it up, they will blow off if not secured properly ! It will blow oil and gas on you like it does out of the carb with a broken reed valve! Well after 7 hours of soldering replaced chewed up wires it Runs after sitting 20 or so years. It doesnt...
  6. T

    1984 mercury bleed lines

    Hi Do you know what manual i need for a 1984 mercury that will show the bleed line routing clearly ? I read about a whole lot of people buying manuals and what they are looking for are not shown. I have ran lines where i think they go by reading a lot. With it sitting 20+ years i just plan to...
  7. T

    1984 mercury bleed lines

    Hi I can see the pictures and post a reply so i dont know why it says i need to be logged in to click on the pictures? Looking at the pictures they dont match what was on my motor .
  8. T

    1984 mercury bleed lines

    I have to try the link on my laptop. Does not work using my phone
  9. T

    1984 mercury bleed lines

    Thank you When i click on the link it says i need to be logged in
  10. T

    1984 mercury bleed lines

    Hello Everyone I bought an old bass boat with a Mercury 150 2 stroke v6 and old age and rats have chewed up the bleed lines and i dont know where to hook them up correctly. My engine has 5 hoses total on the cylinders . 1 to the airbox My motor also has vertical reeds. I have read a ton of...
View older results
Top