Search results

  1. corytha

    Coil

    Tested when cold its in parameters. Did not test when hot. Everything else on motor is new. I was running great before, I will check the SP gap as well, I know that can draw more current and make coil hot.
  2. corytha

    Coil

    I will be changing my coil tomorrow. After motor runs for 40 min or so it cuts off like no gas. Then when cold starts right up. New carb, new fuel filter, new fuel line and water separator, new plugs and wires and points. Anyone had this happen before?
  3. corytha

    Plastic where zinc goes.

    Thanks. Its at 135 when in water all day. I will keep that in mind. Thanks again. Mine in 1989.
  4. corytha

    Plastic where zinc goes.

    Thank you for the information. The motor was service 3 weeks ago. I am a weekend boater. Should I change the impeller yearly? I heard alpha one is hard on the impellers. I fresh water clean after every time i am in the water.
  5. corytha

    Plastic where zinc goes.

    Yes I got the aluminum for the salt water.
  6. corytha

    Plastic where zinc goes.

    Thank you much. I'm a new owner to this kind of motor. I will only replace the zinc above the prop now. My boating area is South Florida so I'm brackish and saltwater.
  7. corytha

    Plastic where zinc goes.

    1989 Sea Ray 16 ft. Have a mercruiser 3.0 alpha 1 outdrive. I bought a zinc kit. The place where I put the square zinc directly underneath the hydraulics for the tilt lift have a plastic piece that is connected with a wire. I cannot put the zinc there because the piece is. Can I cut it off?
View older results
Top