Search results

  1. W

    Lost power on return to ramp screws missing from transfer port caps. 94 force 120

    Thanks Jimmbo, when I went to their parts breakdown for the block it showed the gasket but when I went to the number in the parts list 43 (I think) it skipped over it.
  2. W

    Lost power on return to ramp screws missing from transfer port caps. 94 force 120

    Upon returning to the ramp my engine power reduced drastically. As long as I kept the throttle high the engine would run. Fortunately, I was able to make it back to the ramp. When I got home I took a quick look and there was oil everywhere on the right of the engine when looking from the back...
  3. W

    What style ignition system is this Force 120

    Ok, went to the lake yesterday had test started my motor prior and it fires right up. Got to the lake and put in. Engine fired and ran for about 30 seconds to a minute then quit. I tinkered with it a bit there and found I had no spark. Today I disconnected the black and yellow wire and it fires...
  4. W

    Force 120 fuel running out of the carbs when tilted

    I have a Force 120 that if you've pumped up the bulu and tilt the engine fuel will run out of the carburetors in to the splash well and into the water. I contacted a local repair shop and they told me that this is normal but I can't see how this could be normal if the floats are working is this...
  5. W

    93 force 120 carb problem

    I have been noticing a fair amount of oil in the splash well. Tonight I got around to investigating. Now I think I know the answer but want some confirmation of my suspicion. Prime the engine in the down position and all is well. As soon as you lift the engine fuel runs from both carbs. Now...
  6. W

    Any way of replacing bunks without putting the craft in the water?

    My bunks are in need of replacement. The hardware is rusted and I do not want to attempt the replacement at the boat ramp. Is there a way of jacking one side without damaging the Boat? This is a 18 foot bayliner with outboard.
  7. W

    bunk carpet V. marine carpet

    Is there any difference between marine carpet and bunk carpet? I have left over carpet from my restoration and would like to use it if it is just as durable.
  8. W

    NEED HELP 94 force 120 will not idle in nutral

    I have a 94 120. the engine will idle fine when in gear but will not idle for more than a minute when in nutral. This includes when in the start position. it will start to idle fine but then sounds like it builds up compression and quits. I have checked timing and compression and everything is...
  9. W

    Cleaning water cooling jackets 94 force 120

    I took my thermostat out today to test it. I noticed some sand and a fair amount of oxidation inside the thermostat housing. I am wondering if there is any way to flush the system to get rid of any trapped sand and the corrosion for a good clean cooling system.
  10. W

    94 Force 120 torque specs for the lower unit mounting bolts

    I just replace the impeller on my water pump and have re mounted the lower unit. My manual does not state the torque for the mounting bolts that attach the unit to the upper unit. Since it is aluminum I do not want to over tighten and strip the threads. does anyone know what these should be...
  11. W

    what type of filler to use between cap and transom

    During my restoration I noticed a body style filler was used to take up the space between the top of the transom and the cap which has 2 different angles. When replacing the cap after the resto. there is still a small gap there. what should I use as a filler? I don't like the sounds of...
  12. W

    looking for 94 capri thru hull part in stainless any help?????

    I am looking for the thru hull threaded drain and caps that run through the transom. does anyone know where I can get these in stainless? Came with plastic but would like to upgrade part number is: 34094 THRU-HULL THREADED EA 2 * 34095 CAP-THRU HULL-THREADED EA 2
  13. W

    performance loss with the install of fuel filter/water seperator is this an issue

    I have a 94 force 120 outboard which has n inline filter. if I was to remove that and install a filter/water seperator would this decrease the performance of the engine?
  14. W

    Why you shouldn't just lay new plywood over rotten deck

    A PO did just that with my boat. Here are the results. Every piece of wood MUST be replaced except possibly the main stringers. The better part of the deck
  15. W

    splitting the top from the hull

    Anyone know about how heavy the top half of a 94 bayliner 18 footer bowrider is? how many people will it take to lift and carry it?
  16. W

    trim/moulding parts

    Looking for some place to buy the rubber trim over the screw holes it the base of windshield and repacement rubber for bumper around seam of boat. Any help?
  17. W

    1994 bayliner capri 1800 redeck and restring

    Re: 1994 bayliner capri 1800 redeck and restring Ok, garage is atleat somewhat straight. this is what I am looking at. These are the frames under the bow seats :facepalm:
  18. W

    1994 bayliner capri 1800 redeck and restring

    OK guys you have seen me asking questions like crazy on the subject. Took her out for a last gasp and to get the gas out of her. The Mrs. goes in for some minor surgery in 2 weeks and probably won't be able to be in the water so figured what the hey might as well get started. Will try to upload...
  19. W

    Hate the way search engine works! anoyone have some links to ways to make a cradle

    Need to make a cradle and looking for the best but also easiest way to make a good one. also best way to lift the boat from the trailer to set on the cradle
  20. W

    Unknown pressure guage

    I have a 94 bayliner capri with a 94 force 120. The boat has a pressure guage that reads from 0-30 psi. at wot reads typically around 10-15 psi. contacted bayliner and this is an addon. anyone know what this guage might be reading?
Top