Search results

  1. Kailofsouls

    Help with early 80s mercruiser 140hp

    I ran a small piece of 600 grit sandpaper on the points came out clean. I don't have a feeler gage but everything is tight. So I don't see how it could have changed.
  2. Kailofsouls

    Help with early 80s mercruiser 140hp

    I have a older mercruiser 181ci 140hp 4cyl. Serial number starts as 67 I believe it's around an 82-84. Couldn't get it running after I had a mechanic replace gimbal bearing. After fighting with it and another mechanic even gave up on it, I found that the fuel pump diaphragm was bad dumping gas...
  3. Kailofsouls

    Mercruiser 3.0 won't throttle up

    I've been trying to find a service manual for my motor but everything I find is 50-75 bucks. All I know for sure is I need manual #3. Though I never messed with my point gap. Just checked it.
  4. Kailofsouls

    Mercruiser 3.0 won't throttle up

    My point gap is supposed to be .022 inch approximately the thickness of the cardboard of a cereal box or business cards. I don't have a feeler gage but I did have a cereal box lol. But yes I can move the rotor and it springs back to where it started. Point dose open and close, and I cleaned the...
  5. Kailofsouls

    Mercruiser 3.0 won't throttle up

    If I can get my hands on a battery charger I'll try that.
  6. Kailofsouls

    Mercruiser 3.0 won't throttle up

    Thank you for all the responses. I'll try to answer all of them in this post. There shouldn't be a leak at the gasket it's new and has some gas rated rtv on it. Unfortunately I can't get a compression tester, but it runs at 600rpm so I believe it should be at least passable, but maybe not...
  7. Kailofsouls

    Mercruiser 3.0 won't throttle up

    I'll try a compression test. Will have to rent a gage tomorrow.
  8. Kailofsouls

    Mercruiser 3.0 won't throttle up

    Upon monkeing around I've found that after I rev slowly in neutral and back back off till just before popping it back to center the rpms stay at 1300-1800 and don't come back down till I put it back center. Is that normal operation? Center idle is 600-800 rpm. Motor does shake a fair amount at...
  9. Kailofsouls

    Mercruiser 3.0 won't throttle up

    Fuel is 3 weeks old rec with a can of b12 chemtool. Filters are clean. Choke is always open unless i close by hand. Distributor cap, rotor, points, and condenser are all brand new looking as well as wires and plugs. It seemed ok last year if a little boggy. Only thing I can find is a very...
  10. Kailofsouls

    Mercruiser 3.0 won't throttle up

    Accelerator pump works. I think my choke doesn't work, but it is full open. Running warmed up it Doesn't seem to matter how far I open the mixture screw it stalls on revving motor.
  11. Kailofsouls

    Mercruiser 3.0 won't throttle up

    I have an older mercruiser 3.0 140hp sn 6720261 that has been giving me issues my whole camping trip. So I've been trying to get it running correctly, but every time I throttle up in neutral it stalls. On the lake it won't go over 2000 rpm. If I go VERY slowly it will rev up and roar like a...
  12. Kailofsouls

    73 1150 fuel pump/flow question

    I'm fairly certain that I don't have air in my fuel lines all new lines are hose clamped on. I'm just trying to figure out the direction of fuel flow through the check valves. Everything primes up nicely, but it's not drawing fuel like it's supposed to so it can stay running. Also my quick...
  13. Kailofsouls

    1976 mercury 850 idle problems

    Have you checked the fuel lines? Mine were shot on my 73 1150 they may look ok on outside but inside they could be falling apart. 3/8 from tank to motor 1/4 from pumps to carb was my sizes. I just bought fuel line by the foot at an auto parts store. If you work at the brass fittings you can pull...
  14. Kailofsouls

    73 1150 fuel pump/flow question

    The reason I replaced them was that I replaced all fuel lines, and had to remove the pumps to do it. Figured while I was there that I didn't know how old any of it was, and I damaged one gasket so I replaced everything. The issue is that everything is clean and new. There's no reason that I can...
  15. Kailofsouls

    73 1150 fuel pump/flow question

    So I replaced the dual fuel pumps on my motor but I think I might have my check valves backwards I'm not sure. When I run the motor after 2 minutes or so if I don't squeeze the primer bulb the motor will die. Vent is clear, tank is clean, all fuel lines are brand new, new bulb, and inline fuel...
  16. Kailofsouls

    Possible water intrusion?

    Ok I'm replacing my fuel lines and pumps in a 73 1150 in-line 6. Pulled the upper pump and there is droplets of water behind the diaphragm. I assume that is not normal. What could cause this? The bottom pump is dry behind it and my plugs look normal not washed clean or anything. Compression is...
  17. Kailofsouls

    72-73 Mercury 1150 checking some information

    I was informed by a coworker that what I did was a "dry" compression test so I'll try to get it running to warm it and try again. Attached is a screen shot of my service manual I underlined my timing numbers.
  18. Kailofsouls

    72-73 Mercury 1150 checking some information

    I had another post about fuel pumps. but now I'm on to something else just want to double check my info. fuel pumps are replaced, carbs cleaned (seats and float needles replaced as well as gaskets). Idle screws set to 1 1/2 turns out. The problem is I can't get it to start or stay running...
  19. Kailofsouls

    Mercury 1150 fuel pump question

    I've got an older 72-73 merc 1150 and I need to replace the fuel pumps (older style triangle shape) I can't get to the lower one it's below the level of the lower cowl is there a trick to getting to it without pulling the power head? I can't figure out how to get the lower cowl off otherwise.
  20. Kailofsouls

    77 mercury 1150 no top end

    I have a issue where my engine starts idles great seems to accelerate fine till I get to the last half of my throttle at that point it bogs out sometimes stalls rpms drop off and the boat won't lift up or plane out and can't get over 5-10 mph I just had her running at about 35 mph memorial...
Top