Search results

  1. C

    81 Evinrude 25 HP - Didn't Start

    Recently I did some maintenance work on my 81 Evinrude 25 HP; change all lower unit seals, replace waterpump & housing, new thermostat, and replaced the neutral start switch becuase there wasn't one on there when I bought the motor used. Long story short I got everything back together, did...
  2. C

    Pressurizing the Crank Case

    I have an 81 25 HP Evinrude, and I'm in the process of changing out all the lower unit seals and water pump, etc. I now have it all back together and look to re-attach to exhuast housing. I read some things stating to check the pressure or to pressurize the seals to check for leaks. My questions...
  3. C

    1978 Seafarer 14 - Port Side Handle Plate

    Doea anyone know if the dealers can get the handle plate that has the star on it, that goes on the rear port side. Or if there is somewhere else I can get one. I would like to get one because a previous owner sawed the handle part off to make clearance for an anchor pulley system. Your help is...
  4. C

    Evinrude 25 HP Lower Unit Seal Strip

    See attached parts page for reference. I ordered a lower unit seal kit, Sierra P/N: GLM87619, here from iboats.com for my 81 Evinrude 25 HP E25RCIM. The seal strip, #52 on the attached parts page, seems a bit to thin in diameter. It doesn't fit snug in the channel. According to the service...
  5. C

    Shaft Seal at Water Pump Housing

    Re: Shaft Seal at Water Pump Housing I agree that's what it looks like per the parts page, but I don't see how it can based on how the pump housing is made. See below.
  6. C

    Shaft Seal at Water Pump Housing

    See attached sheet. I have an 81 Evinrude 25HP E25RCIM. Where is the seal that is provided with the water pump repair kit supposed to go; see item #14. The pump housing has fins, for a lack of better words, on the underside keeping the seal from being placed between the housing and cup, and the...
  7. C

    81 Evinrude 25 HP Shift Rod Bushing and O-ring

    Re: 81 Evinrude 25 HP Shift Rod Bushing and O-ring So it would be installed between the gasket and bushing as shown on this parts page, correct? Out of curiosity is the bushing, cut out for a lack of better words, to receive the o-ring? If not do you just re-install the bushing with the shift...
  8. C

    81 Evinrude 25 HP Shift Rod Bushing and O-ring

    I have an 81 Evinrude 25 hp (E25RCIM). I have the shift rod bushing and o-ring on order. I assume the gasket goes in the bottom of the hole where the bushing goes, but where does the o-ring go? Also, is there some sort of punch I can fashion to get the bushing out, without having to pay $200+...
  9. C

    1978 Seafarer 14 Max HP

    I'm new to this forum, and forums in general. I have a 1978 Starcraft Seafarer 14 and it's titled with HID# as STR090510678. I've searched the internet through and through including this website (iboats) and what little I can find states that the MAX HP is 30HP. My capacity plate is gone. This...
View older results
Top