Search results

  1. iwaterdave

    Does my outboard need a pee hole?

    I swapped a 86' to for a broken 89' powerhead. The 89' did not have a pee hole exiting the engine but I noticed the 86' does have a pee hole right next to the thermostat. Is it necessary or should I plug it and allow more water to run throughout the engine at running speeds? Thanks, Dave
  2. iwaterdave

    Force Parts Online?

    Anyone know any place online that is reputable for buying Force outboard gaskets and parts? I just took my flywheel off of my 86' 125 Force and the key went flying or it was just sheered off. Not sure where it went. I tried a few local store sites like www.seawaymarine.com and...
  3. iwaterdave

    86' Force Timing issue

    I'm new to boat outboard motors. I wanted to set the timing and idle speed according to the manufacture repair manuel. I bought a timing light that says it can switch from 2 cycle and 4 cycle engines. I connect it and it shows the idle speed jumping about 200 rpm up and down. (1000-1250) Also is...
  4. iwaterdave

    '86 125 Force tempature question?

    I just installed a temp gauge on my dash and it seems to work fine but I notice something odd as the engine is warming up. The lower half of the head is getting hotter faster than the upper side of the head. Is this normal since it's closer to the exchast? or should I be looking for a gasket kit...
  5. iwaterdave

    marine deep cell vs marine starting battery

    Is there any difference between a deep cell and a marine starting battery? I have both but use one to run my trolling motor. Can I use the starting battery if I need to to troll with?
  6. iwaterdave

    Charging for a '89 125 Force?

    Can anyone tell me if my '89 125 Force outboard is charging my battery when running?
  7. iwaterdave

    White smoke from the back of my 125 Force

    New to outboards so maybe this is nothing. I noticed this white smoke coming from the back of the outboard while on the water. Does it more when I idel. is something wrong?
  8. iwaterdave

    125 Force in Forward and engine dies... Reverse and engine dies...?

    1985 Powerhead on a 1989 125 Force Outboard I just got back from a test run after fixing my last problem witch was it would not stay started for longer than 1 sec. I adjusted the shifter bolt at the front center of the engine and now it starts. 1st problem fixed. 2nd problem... Now when I put...
  9. iwaterdave

    Is water suppose to come out of this hole?

    I'm not sure if water coming out of this hole is ok or not. It's an 85-89 125 Force combo outboard. Exhaust does come out but water also sprays out too. Is this normal?
  10. iwaterdave

    What is this?

    I'm new to boating and I just bought this '89 Bayliner Capri about 3 weeks ago. I'm looking under the dash and I have no idea what this is. Can you help?
  11. iwaterdave

    125 Force starts but dies after 1 sec

    I have a 1985 125 Force powerhead on a 1989 125 Force body. I had it running this last weekend but noticed neutral was off buy just a tad towards the reverse. So I made some adjustments to the linkage after following the directions from the manuel. Then had trouble getting power back to the...
  12. iwaterdave

    Swapping a 1986 and 1989 power house (engine)

    I'm considering buying this 1986 125 Force to swap the main motor top half with my 1989 that came with my 89 boat. It currently has a crack in the block. Will they match up and work?
View older results
Top