Search results

  1. C

    Evinrude 9.9 HP Model # 10924B

    I am certain the Zodiac folks can tell you what to do to glue a patch and what glue to use. try some googling https://www.amazon.ca/zodiac-patch-kit/s?k=zodiac+patch+kit
  2. C

    1973 4hp Evinrude

    you don't need a fancy timing light to service a 4hp. Just set points at .020 with the cam lobe's high point or use the voltmeter test. Yet .020 isn't all the t important was is .. is that point open at EXACTLY TDC the VOM will tell you or a simple LED or bulb on a battery will tell you...
  3. C

    Evinrude 9.9 HP Model # 10924B

    if you ever decide to open and service those square pumps keep an eye for small springs and tiny mushroom caps. To re-assemble I put on small drop of crazy glue on the spring's locating dimple and on the mushroom caps to secure then on the spring ends so they don't fly off to never to...
  4. C

    Evinrude 9.9 HP Model # 10924B

    these small pumps are everywhere on amazon and folks like or don't like them. I have used them with no problems but if you do want oem any dealer will surely have these pumps or order it . rebuilding the pump is easy after you have done a few first one is always tricky read read read ...
  5. C

    1990 Johnson 15hp only start with carb disengaged

    the roller is set centered to the cam but at the tiller arm it's maxed full slow so I can only go full throttle from there. ???? if the cam follower is centered on the mark the tiller should be at or close to START....works like that on all obs ... if you rotate the tiller to FAST the mag...
  6. C

    1992 Johnson TJ25ELENS 25 hp

    check venting ...try hand pumping fuel in case fuel flow is impaired check fuel pick-up. does PH get HOT !!! check water flow is water to hot !! recheck for sparks when it does not restart after idle shut down. did you clean out the drip chamber under the welch plug when you did...
  7. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    dying comes bad fuel flow no sparks or bad condensers shorting out under heat.
  8. C

    1968 3hp Johnson

    line up the coils !!! no reason to rub on te FW...
  9. C

    1998 Evinrude 60HP 2 stroke Slow Max Speed

    stuff happens... even if you did clean the carbs. recheck fuel supply from tank to carbs if sparks are OK check venting , fuel pick-up etc...
  10. C

    2006 Johnson 15 HP 4 Stroke bogs when snapping throttle

    the bulb becomes hard again only if you pump it up and a full carb stops further inlet of fuel with the inlet needle/float ( works like a toilet bowl) . if the fuel does reach the carb to fill it up with other no benefits the pump is likely ok. now look for carb or ignition problems ...
  11. C

    Golden Jubilee Evi Sportwin 10 - Should I convert?

    with my kit I have a tool to seat the insert in place by punching it with a hammer blow. this is to lock those little perimeter spikes in the surrounding material . see video at 4:27
  12. C

    2006 Johnson 15 HP 4 Stroke bogs when snapping throttle

    the bulb never gets " hard" as it is subjected to negative pressure from the fuel pump.
  13. C

    2006 Johnson 15 HP 4 Stroke bogs when snapping throttle

    normally if the pump was bad simple hand pumping fuel should refill it and carb and prove the pump is bad...have you tried ?
  14. C

    1998 115 (E115SLECM) VRO leaking fuel

    lots of utube on fixing VRO or... going pre-mix.
  15. C

    1979 55HP Johnson

    pull up some UtUBES... an impeller change is not a big job just keep an eye on PH overheats to save an impeller !
  16. C

    1979 55HP Johnson

    I have use ethanol fuel all my boating life since sold & currently in my 75HP ETEC never had any problems and the boat is stored 6 months fully fueled with 87 octane + fuel saver cycled in before storage. don't tilt up to much if not needed and see what happens.
  17. C

    1979 55HP Johnson

    couple things...oily soot is just carbon deposit washout and should eventually stop in nothing abnormal top side. fuel leak..excessfuel leak with engine tilted up can happen with full carbs but a carb should normally stop the inflow of fuel if the inlet needle closes properly... if...
  18. C

    Evinrude 9.9 HP Model # 10924B

    assuming you have done a good carb cleaning and ignition is ok check (open) venting on the tank and small fuel pump screen and try hand pumping the fuel to the fuel pump if it clears the problem ( it stays running) the fuel pump may need a new diaphragm or replacement altogether...
  19. C

    Hard start but runs great once started

    try hand pumping up some fuel in the carb ... before starting it. using choke ?
  20. C

    '86 Evinrude 60 VRO E60TLCD with water in #3

    delete
Top