Search results

  1. K

    Mercruiser 5.7 with V6-14 TB IV module??

    OK so we're moving in the right direction. I'm able to get the engine to run but only with starter engaged. Issue was not getting fuel....that's another issue I'll tackle next. In the mean time I believe the purple added wire from the starter to the + of the coil is not supposed to be there...
  2. K

    Mercruiser 5.7 with V6-14 TB IV module??

    Ohm on coil. Threads are pretty stripped and I do not think it's a OEM coils
  3. K

    Mercruiser 5.7 with V6-14 TB IV module??

    Mine has 4 wire actually. 2 wht/grn, 1 wht/red, 1 black Also just tested the coil. Primary is 3.1 ohms Secondary is 9k Should primary range be .6-.8 and could that be stopping ignition?
  4. K

    Mercruiser 5.7 with V6-14 TB IV module??

  5. K

    Mercruiser 5.7 with V6-14 TB IV module??

    Going home now to reset to TDC
  6. K

    Mercruiser 5.7 with V6-14 TB IV module??

    It does have three wires, two wht/grn and one wht/red
  7. K

    Mercruiser 5.7 with V6-14 TB IV module??

    Good morning, I have a 1998 Sunesta 232. It currently has a 5.7 Mercruiser and TB IV ignition in it. I removed the DIZZY to drill out some broken cap screws, and it was running before I did this. I believe the engine was swapped out by a previous owner. I have verified the block is from a 1987...
  8. K

    Alpha 1 Gen 2 limit switch bracket

    Good Evening, I'm in the process of installing both the limit switch and the position switch. When tightening the bracket against the transom plate, it goes around both halves of the limit switch cables to make the water-tight seal as they pass through the transom plate. What I'm noticing is...
  9. K

    Mercruiser Oil Gauge pegged KOEO

    All, I'm happy to report that the new gauge arrived and corrected the problem. It must have been an internal short in the old gauge. Thanks for the help. Komodo
  10. K

    Mercruiser Oil Gauge pegged KOEO

    QBhoy, thanks if the replacement gauge does not work ill buy a euro sender. do you by chance know the P/N?
  11. K

    Mercruiser Oil Gauge pegged KOEO

    Hello, I have been troubleshooting the oil gauge (P/N 73180), which is pegged at 80 psi, and am at my limit for troubleshooting, so I need assistance from the forum if anyone could. Below is what I have done to T/S thus far to troubleshoot. 1. This is the original condition when I bought the...
  12. K

    Not permitted

    what is not permitted Hello, Did I miss a sub-forum rule set that would have alerted me to this post not being allowed?
  13. K

    Not permitted

    MOD edit: not perminted thanks, Ken
  14. K

    Alpha I Gen II Gear Oil Leak

    Hello, So I have had a gear oil leak coming from my outdrive that has accumulated. and as it leaks, it fills up the orifice around the lower shift shaft and leaks out of the weep hole on the lower outdrive. Today I finally removed it to start troubleshooting and rebuilding. I did not conduct a...
View older results
Top