Search results

  1. alldodge

    I/O (Sterndrive) Conversion to Outboards

    We have all our ski stuff but haven't been since before covid also, do see us going again
  2. alldodge

    Switching from Volvo TBI to Carb on a 1996 5.7 GI

    Permatex Aviation Sealer Carter makes a good pump and if the pump and I'm skeptical it's actually leaking there. I would think it's leaking at the fitting The part that screws into the pump is NPT right?
  3. alldodge

    Having Hot Start issues

    Need a scanner Going to need some actual readings and measurements Is fuel pressure between 50-60 psi from idle to WOT? Use a Noid light to see if injectors are turning on/off when cranking/running and that they don't stay on with motor off and key on
  4. alldodge

    Switching from Volvo TBI to Carb on a 1996 5.7 GI

    What's the blue sealer on the threads? If that's silicone, don't use that
  5. alldodge

    Bravo 1 Question?

    Bravo ratios are done in upper and lower, and Bravo can be run in either direction without issue. If your talking about B1 then they are upper only unless your talking about XR
  6. alldodge

    Unknown electronic device in bilge... Is it motor or out-drive related?

    Look for digital depth gauge
  7. alldodge

    Trailer wheel bearings - standard or stainless

    Every bearing will rust "IF" water gets in.
  8. alldodge

    Switching from Volvo TBI to Carb on a 1996 5.7 GI

    Your good to go, and like Scott said your won't hear it and even if you do it's fine
  9. alldodge

    Having Hot Start issues

    If you bought the injectors from Ebay or Amazon than most likely they are junk. Injectors can not be rebuilt only replaced
  10. alldodge

    Mercruiser 350 MAG MPI

    Original problem was a hot start issue and now after injectors came back from testing the motor is flooding. While the hot start issue may have been vapor lock, this issue is most likely the injectors
  11. alldodge

    Switching from Volvo TBI to Carb on a 1996 5.7 GI

    When cranking you should get 12V on pin 85 of the relay when cranking. If it's not there check to see if your getting 12V on the Yellow/Red wire on the key switch when cranking If 12V when cranking on key switch and not on pin 85, then it's probably the diode. Check for 21V on both sides of...
  12. alldodge

    Battery cable

    Use a measuring tape and get a ball park including the jacket. Go to local store and see what comes closest, and can always buy larger
  13. alldodge

    High RPMS instant rpm drop to zero and back

    I would look for a loose connection, maybe @racerone may have other ideas
  14. alldodge

    Battery cable

    Solid wire should only be used where vibration is not an issue. The current carrying capability is higher for solid wire but not that much more
  15. alldodge

    Battery cable

    Measure the diameter of the wire and do not include the insulation jacket https://www.firgelliauto.com/blogs/news/understanding-wire-gauge-sizes-awg-101
  16. alldodge

    Having Hot Start issues

    Welcome, looks like your using a parts cannon on the motor. Replace everything and you still have a problem. Replacing parts can add to and mask what is really happening. Must say you must have plenty of money to throw at it What is motor serial number? What was your fuel pressure readings...
  17. alldodge

    Maybe my turn for new boat time

    Either way my point is, it's not on a lift. I've had paint removed and re-painted but don't really want to do that again, but would be willing if cost was lowered enough
  18. alldodge

    Maybe my turn for new boat time

    Have been watching it and it's a slight "maybe". Hours are ok but it's been bottom painted and probably spent it's life sitting in saltwater except during the winter. There was a 2024 model in FL that was 20K more, but it's gone now
  19. alldodge

    Maybe my turn for new boat time

    Don't know what they would sell one actually for because a 2 year old with V8 is selling in the 280K range. So they sell much less or there is one heck of a deprecation.
  20. alldodge

    Maybe my turn for new boat time

    New is always pricey an new always list MSRP, and looking into performance V8 300 and V10 350 isn't much due to added weight Been in discussion with Formula in Decatur but they have no used currently. Sent me links to a 2025 with V8 and 2026 with V10 V8...
View older results
Top