Search results

  1. alldodge

    Draw on battery 1

    Read thru your thread For clarification you are discussing the 2006 Rinker, right? Your disconnecting the Mercathode lead which, make sure it's disconnected by measuring voltage on the module. Keeping boat on trailer you can leave the Mercathode disconnected Being a 2006 the motors should not...
  2. alldodge

    Switching from Volvo TBI to Carb on a 1996 5.7 GI

    As Scott said coil is fine Timing is done as follows the difference will be DO NOT use timing listed (2*), you will need to use most likely 8* BTDC. You also do not have a shift interrupter
  3. alldodge

    Switching from Volvo TBI to Carb on a 1996 5.7 GI

    Yes that's a EST, just use it
  4. alldodge

    Switching from Volvo TBI to Carb on a 1996 5.7 GI

    The DUI will work and several have used it Merc and VP used Delco EST
  5. alldodge

    What razor and single razor blade in it are available ? CHEAP Who sells such a simple razor and holder ?

    Sounds like what G-dad always said
  6. alldodge

    I/O (Sterndrive) Conversion to Outboards

    Hey Ted, as a Mod you could delete all these non-conversion comments and clean up the thread ;)
  7. alldodge

    496 overheating

    Could use your serial number but, your motor has a temp sender for the gauge, and a ECT (engine coolant temp) switch which tells the ECM it's hot. The ECT is item 7 in link https://www.mercruiserparts.com/bam/subassemblydetail/43086238/28188353
  8. alldodge

    Yamaha 9 .9 high thrust

    With only 12 hours I would guess it's made that way. Might stop by a dealer and ask just to make sure
  9. alldodge

    What razor and single razor blade in it are available ? CHEAP Who sells such a simple razor and holder ?

    Your old enough, you should know the answer to the question Straight razor and leather strap will last longer than anyone of us and our grand kids has been alive
  10. alldodge

    Is it my PC, cookies, IP address or...

    Use something like firefox and get no adds
  11. alldodge

    What could these brackets be for?

    Taylor made fender lock Fender
  12. alldodge

    Volvo Penta engine coupler runout … aka wobble

    It should be solid and hard, being able to move it than the coupler is toast and needs replaced, crank is fine like Scott said
  13. alldodge

    Volvo Penta engine coupler runout … aka wobble

    I wouldn't pay much attention to what's happening on the outer piece, need to check the inner Use a 1 inch bar or other and get a dial indicator reading on runout
  14. alldodge

    Boats from work.

    Looks good, nice work but... What no vacuum ;)
  15. alldodge

    New Members - Welcome To The iBOATS Forum - Introduce Yourself And Say Hello

    It's on Iboats Forum "and" website issues This is where new members would come to find out things about the Forum (how to do things) , so it's in the right spot.
  16. alldodge

    Boats from work.

    Hind sight, look up slim Jim to unlock the door Look to remove back seat to get into trunk. Might be able to reach in and pull inside latch in trunk
  17. alldodge

    New Members - Welcome To The iBOATS Forum - Introduce Yourself And Say Hello

    If it goes to dock side it will get buried and lost. This is a sticky and has been in same location since 2016.
  18. alldodge

    Volvo Penta engine coupler runout … aka wobble

    Support the rear of the motor and than remove the bolts holding the bell housing
  19. alldodge

    Switching from Volvo TBI to Carb on a 1996 5.7 GI

    Two things Your VP low pressure pump may not need a reg, it might but might not, check/test first The Holley Reg limits the amount of pressure going to the carb, it simply does not allow any fuel above the adjusted pressure to pass, no need to overflow line. Same thing a house water pressure...
  20. alldodge

    Jeez! What happened to global warming

    Mic drop
Top