Search results

  1. flyingscott

    1983 140hp Suzuki or a 115hp 96 Johnson ocean runner

    The Suzuki is an excellent motor. Problem is Suzuki has not kept up with parts supply. No aftermarket support for them. The aftermarket is taking up a lot of slack for the OMC motors. Nothing for Suzukis that old. That Suzuki is as obsolete as my McCulloch 75 hp.
  2. flyingscott

    1977 Evinrude 25 Oil leak

    Don't forget no more natural gas stoves, furnaces and hot water heaters.
  3. flyingscott

    Rebuilding 1980 johnson 35 Cant split the case?

    Take the intake off and make sure all the bolts are out. Where did you find a camshaft on a 1980 evinrude 35 hp?
  4. flyingscott

    1994 merc 115

    Take the lower unit off and see if it turns. Those were actually good motors
  5. flyingscott

    How much outboard motors have improved.

    All I know is that motor gets better gas mileage than my Geo Metro did.
  6. flyingscott

    Engine update

    85 and below would be the easiest and nothing newer than 87.
  7. flyingscott

    How much outboard motors have improved.

    He is burning a gallon an hour of fuel at 3/4 throttle. Explain how that motor is not running lean. Don't know what's confusing about it.
  8. flyingscott

    How much outboard motors have improved.

    I owned that exact motor THats ok if your #s are right that motor will burn down soon enough. No way does it survive with that little fuel in it. We will see you in the Merc section soon enough.
  9. flyingscott

    How much outboard motors have improved.

    How is this post still going? So obvious we are being trolled. In WHAT universe do the Ops #S MAKE SENSE!. His last post was what a gallon an hr at 3/4 throttle? I will call that for what it is BS!
  10. flyingscott

    Fitting Solas Prop to '65 Fastwin 18

    SKU:M359-2111-093-11P
  11. flyingscott

    EVINRUDE 25 hp lower unit

    I believe 82 and earlier will fit. You will need to check the parts fiche to be sure. There was a spline change around then.
  12. flyingscott

    CROSSFLOW PERFORMANCE ?'s

    When did that start? I have found plenty of bad stators by being out of spec.
  13. flyingscott

    Shaft extension

    Try bay manufacturing
  14. flyingscott

    1977 Evinrude 85hp - Oil Leaking from Air Silencer Cover

    You will need a new one the permatex will not stick to oil.
  15. flyingscott

    1977 Evinrude 85hp - Oil Leaking from Air Silencer Cover

    Buy the best gasket you can OEM if possible. The thinner cork used today does have more of a tendency to leak
  16. flyingscott

    1977 Evinrude 85hp - Oil Leaking from Air Silencer Cover

    This is such a ridiculously common problem on these airboxes.
  17. flyingscott

    1977 Evinrude 85hp - Oil Leaking from Air Silencer Cover

    Use aviation permatex to hold the gasket in place then torque it correctly. The oil was always in there you just never saw it. ALL carbs leak when you tip the motor up.
  18. flyingscott

    Evinrude 9.5 how long until thermostat opens

    When was the last time the impeller was done
  19. flyingscott

    1977 Evinrude 85hp - Oil Leaking from Air Silencer Cover

    Use aviation permatex on the cork gasket. You will probably find the bottom has pushed out causing the leak.
  20. flyingscott

    1977 Evinrude 85hp - Oil Leaking from Air Silencer Cover

    Really clearly said the box had never been off before. So ask the op if he has x ray vision. And brush up on how carbs work. And the evaporative properties of gas.
Top