Search results

  1. R

    Need help with identifying motor

    Agreed it is normal when idling / running in the driveway.
  2. R

    Kiekhaefer Mercury KE-4 ignition question

    Looked in the flywheel ???----Post picture of inside of flywheel.
  3. R

    Outboard loses prime, unless I stand the tank on end

    I think it is simple.----Some of these tanks today have ---JUNK----pick-up tubes inside.
  4. R

    1971 7hp Eska sears ted Williams (water issue)

    Those lower units are easy.----I was repairing them at 18 years old as mechanic at a Johnson dealer !-----Is water 6 or 7" above the impeller in your test bucket ?----Thermostat in place ?
  5. R

    1993 mercury 175hp carb

    Post the compression test values.
  6. R

    1990 90HP E90TLESB rough at low RPMs

    Post the actual compression test values.
  7. R

    1971 7hp Eska sears ted Williams (water issue)

    Should not need an Eska with that fine 66 ( ? ) Johnson on the transom.
  8. R

    Outboard loses prime, unless I stand the tank on end

    Inspect pick-up tube inside the tank.
  9. R

    1956 5 hp Gale Buccaneer

    Your location ?-----A new one would be $155.00-----Plenty of used available I think.
  10. R

    1990 90HP E90TLESB rough at low RPMs

    Mixing gas and oil at 50:1 ?-----Or is VRO in service and tested ?-----Or conventional fuel pump mounted directly on the intake manifold ?
  11. R

    How to install a hull lift point?

    I have taken a 30" boat off the trailer by myself.------And put it back on the trailer by myself.------Just a 5 ton jack and some common sense.
  12. R

    johnson 88 spl issue

    Are you pushing the key in and holding it in while cranking it over ?
  13. R

    How to install a hull lift point?

    I use a hydraulic jack to lift boat from the bottom.
  14. R

    1998 Force 120 Stalls out in Low Gear

    Parts list seems to show a temperature switch.
  15. R

    1976 Mercury 500 only runs for a few seconds

    Is the gasket between the carburetor and block the correct one ?----Some have 1 wee hole for the crankcase PRESSURE pulse.----It must line up correctly !
  16. R

    18 horsepower 1969 evinrude

    Way too hot a 214 F
  17. R

    Swap 1978 9.9 hp piston on 1987 9.9 hp powerhead

    What kind of drill bit would be used to drill these connecting rods ????
  18. R

    1988 Johnson 140 v4 wont idle right and won’t go WOT

    Looked into issues with seal rings ( crankcase compression ) on the crankshaft ?------Possibly broken crankshaft seal rings.
  19. R

    Merc 35 horse

    Is it a 1965 or 1987 model ?------Likely good when it left the factory I think.
  20. R

    Overheat alarm at idle... I think??

    Is the buzzer itself defective ?
Top