Search results

  1. Alumarine

    prop nut tightening

    Works just fine.
  2. Alumarine

    Orange/Black Carpet

    If I remember correctly if it's like my V179 it's mostly orange with black fleck. I replaced it with grey about 40 years ago. I think you're going to have a hard time finding an exact match.
  3. Alumarine

    What kind of dashcams is everyone using?

    Viofo A119 Mini 2 - front only. Works well as long as I remember to mount it below the tinted strip at top of windshield...
  4. Alumarine

    Service Manual

    Looks like it's manual 7 part number 90-12410
  5. Alumarine

    Identify the thread of this screw from my boat

    While the OD would indicate #10, if in the 2nd picture the caliper is set for 1" I only count 10 threads per inch. Not sure what it would be then.
  6. Alumarine

    Alpha 1 drive quick question

    It looks like you're missing the welch plug. On my MC1 drive it's part number 19-32652
  7. Alumarine

    Fuel Tank incorrectly labelled?

    Is it possible for you to measure the height, width and depth? If so, you can determine the capacity.
  8. Alumarine

    MC-1 to Alpha One Conversion

    What was the original motor that was attached to the alpha 1 outdrive? It would be best if it was from a 120/140/3.0 so the gear ratio would be correct.
  9. Alumarine

    Prop suggestion for 1995 60 hp Merc 2 cycle

    Without a tach it's hard to determine what's best. If it's getting out of the hole ok I'd stick with what you have.
  10. Alumarine

    Prop suggestion for 1995 60 hp Merc 2 cycle

    Need more info to help. What's the diameter of current prop? What rpm's are you getting at WOT and what's the recommended WOT? What's your top speed now?
  11. Alumarine

    Merc Alpha One trim/tilt Q (feeling like a newby)

    There should be manuals available on ebay. If you provide the serial numbers of the drive and motor and approximate year, someone can point you in the right direction.
  12. Alumarine

    Kicker motor vs towing

    My Honda kicker weighs about 85 lbs. I've towed many miles with it and no issues. I keep the motor in the down position. I have an OMC bracket, can't speak for panther.
  13. Alumarine

    question on the starting a "2 cycle Merc" sticky

    Older 2 strokes have there own ways to start especially cold. Whatever works is the correct method. Advancing the throttle by pushing that button accomplishes the same thing as the idle control lever. You don't mention anything about using the choke?
  14. Alumarine

    Temp sender removal …

    I don't know what you're working on but you try heating the block around the sensor. Maybe with a pencil torch. I'd try a square type ez out.
  15. Alumarine

    Harmonic Balancer pulley of Mercruiser 3.0 replacement

    Heat it up in an oven and tap it on. Make sure you don't melt the rubber. Google "heat harmonic balancer in oven" for some ideas.
  16. Alumarine

    Harmonic Balancer pulley of Mercruiser 3.0 replacement

    Is the pulley you need the one that's on the water pump or the pulley that's on the front of the crankshaft?
  17. Alumarine

    Harmonic Balancer pulley of Mercruiser 3.0 replacement

    You should compare the two. I think the 2.5 uses just a pulley and the 3.0 uses a harmonic balancer.
  18. Alumarine

    Mercruiser 3.0 overheated, Is my motor shot?

    No need to disconnect fuel line. With it disconnected there's a good chance fuel might go where you don't want it. As others said, there's something wrong with the gauge or maybe it wasn't screwed in enough.
  19. Alumarine

    Sea Pro 195 F/S fuel tank size

    Welcome. If you can get at the tank to measure it then you can google "determine rectangular tank volume" to find the capacity.
  20. Alumarine

    Mercruiser alpha 1 gen 2 alarm sounding

    Even with the short video you can see the temp gauge go up slightly. You could disconnect the wire at the temp alarm sender and see if the alarm goes off just over 170.
Top