Search results

  1. alldodge

    Location of fuse box on OX 66

    Search auto reset breaker, you will find them It's basically a temp breaker. Current passes thru contacts until it gets so hot that the breaker contacts separate. When it cools back down contacts pass current again. Used a lot on heavy equipment
  2. alldodge

    Dean's List gets another motor

    Original motor is stripped and put back in the crate. Started putting things back on rebuild and 2 issues came up. Oil port below the distributor had a plug installed by the machine shop, WHY we have no idea. Would not be a major problem but the dog turd guy also used some kind of loctite and...
  3. alldodge

    2013 Volvo Penta 4.3GL Oil Pressure Drop & Valve Tapping / Rattle

    Lifters will not cause pressure to drop
  4. alldodge

    2000 5.7 gsi fuel pump relay problem

    There is no ground being applied by the ECM "or" there is a break in the wire. Always thought Bob did a good test but not felling good about this. Look real close at the pin on the ECM and make sure its making connection. If it is contact Bob and ask him about it, this is really the only...
  5. alldodge

    2000 5.7 gsi fuel pump relay problem

    Take a light bulb and put 12V on one side leave the other side disconnected. Put the negative meter probe on the negative battery post. Now if you take the positive probe and put on either side of the bulb you will read 12V because the other side of the bulb is not connected to anything. If...
  6. alldodge

    2000 5.7 gsi fuel pump relay problem

    Yes, but only for a couple seconds when key is first turned ON. Once ECM removes the ground you will see 12V again Did you tell Bob that it was a fuel pump issue? Not that he needed to know but I'm assuming it would help make sure the problem your trying to fix
  7. alldodge

    01 SeaRay 6.2 MPI intermittent no crank no start

    Sounds like a bad connection. Disconnect and clean to shinny metal on both ends of both battery cables, including the ground. Then disconnect the 10 pin engine connector and clean the pins
  8. alldodge

    Wheel bearing grease "oozing"

    Think the seal on the bearing buddy may be the issue
  9. alldodge

    1993 285 Exhaust question

    Most drives have what's called relief ports in the lower side. Alpha drives have then in lower transom assembly. My guess is omc has similar
  10. alldodge

    1993 285 Exhaust question

    Moved to OMC because it's about the drive and not the boat
  11. alldodge

    2013 Volvo Penta 4.3GL Oil Pressure Drop & Valve Tapping / Rattle

    If your loosing oil pressure it's not normal and 10w40 should be plenty to keep it up. Put a mechanical gauge on the motor to verify pressure is dropping and if it is then there is a problem.
  12. alldodge

    350 Mag Mpi hard to start when warm or hot

    We're still guessing, need to scan the motor and see what is happening
  13. alldodge

    Interesting new on the water fail

    Need a lot of beer to get rid of that taste, hope it doesn't come back anytime soon
  14. alldodge

    2006 Mercury Verado 200, possible pencil coil issue?

    Similar happened to me on my 4 stroke seadoo. Startyed running rough and missing and thought it's a 4 stroke, should not need plugs. After other things that's exactly what it needed
  15. alldodge

    No power to ignition

    Most likely something was wired wrong. Check fuses and look for ignition fuse
  16. alldodge

    Need Optimax Gurus - at wits end!!

    No expert but with pressures being where they should be (I looked them up) you need to scan the motor for codes and problems
  17. alldodge

    2007 4.3 Volvo Penta, what are these, and why is there 2 ( on each side of block )

    The piece on top is a knock sensor. If the motor starts to knock the ECM will retard the timing to protect it
  18. alldodge

    496 bravo 3 3000 RPM plus overheat

    I've done the replacement and know of no way to do it without removing the drive and bell housing. The motor does not need to be removed but then again I was able get to the back of the connection even though very tight If you can remove the fitting that connects to the raw water pump hose and...
  19. alldodge

    Volvo Penta 5.0 GXI-E - Won't roll over

    If t was mine I would not be worried, the magnet is doing its job
  20. alldodge

    2004 Volvo Penta 5.0L OSi engines w/ duo props not getting on plane

    It's scan time,
Top