Search results

  1. alldodge

    Bravo 1 low water pressure

    When cold my mechanical gauge (open cool, attached to block drain port) showed at around 7 psi cold. Thermostat opened and would see 4 to 5 psi. Cruising (3600 to 3800 RPM) would see around 25 to 30 and on end of year 2 on impeller would see 20 - 25 at cruise
  2. alldodge

    Bravo 1 low water pressure

    No The valves are below the exhaust Mans, and any place where there is a self drain check valve (Did I mention I hate self drain systems) :mad:
  3. alldodge

    Bravo 1 low water pressure

    Don't know for sure but I would Connect a garden hose to lower side. Turn water ON but at low flow. The check balls should restrict the flow a good amount
  4. alldodge

    Ideas on getting lake water temp sensor w/o drilling into hull?

    For me was to find out if it's warm enough to jump in :cool:
  5. alldodge

    Ideas on getting lake water temp sensor w/o drilling into hull?

    I had a deck drain that came out under the swim deck and ran the cable from the Dept/Temp sensor thru the drain. Tie-wrapped the sensor to the trim tab.
  6. alldodge

    My boat is being a boat . . .

    Bummer, how about swapping the pressure sensors
  7. alldodge

    Alpha One Gen II shift shaft seals

    Then looks like the original bushings are probably just as good as the new ones. Its all up to the seals.
  8. alldodge

    Alpha One Gen II shift shaft seals

    Are the seals in the bearing?
  9. alldodge

    Bravo 1 low water pressure

    Might be the check balls on the exhaust Assuming it's open cooled
  10. alldodge

    Bravo 1 low water pressure

    Serial number? Is the impeller new?
  11. alldodge

    HELP! 2015 Bravo 3 reverse shifting

    What's caused the warning buzzer to go off? Being a 2015 does it have digital shift? What's your serial number?
  12. alldodge

    HELP! 2015 Bravo 3 reverse shifting

    Is the gear lube bottle empty? When was the last time the drive lube was changed?
  13. alldodge

    Orangish layer on boat will not come off

    Scotch Brite pads maybe
  14. alldodge

    Low fuel pressure, fuel filter half full while idling.

    The Reg that goes back to the filter is under the port side motor mount. There is a black plastic cover over the pump and Reg, Need to remove the cover so you can trace the line back to the filter The filter should have 3 lines on it. Rubber from the tank On top of the filter head there are...
  15. alldodge

    Mercruiser 502 (7.4l) turning over slowly, won't start.

    If it was left outside check oil level. If level is higher, water might have got in
  16. alldodge

    Mercruiser 502 (7.4l) turning over slowly, won't start.

    What is the history of the boat? Is it new to you, was it running fine prior?
  17. alldodge

    Volvo Penta Drive Belt - Lots of dust and quickly wearing??

    Have not heard of that happening, but then again I never tried running that size amps The fusion is 1400 watts 80A fuse recommended The Rockville is 3500 watts 80A fuse recommended
  18. alldodge

    How to actually BOOK a flight online?

    What happens when you go straight to the Airline?
  19. alldodge

    1989 Ranger 350V restore

    Fiberglass work is all so not fun
  20. alldodge

    How to remove Helm Lid

    Will be today or tomorrow. Adjusted the lift Thursday but now need longer bunk boards. The local lift guy said he will bring them today, but this is the same guy that I waited 3 years to get him to do another adjustment. I gave up and adjusted my self, then the next week he shows up, go...
Top