Search results

  1. Scott Danforth

    Boat painting

    so you didnt check the sticky on urethane paint and hardener for under $100? link 19 https://forums.iboats.com/threads/how-tos-and-other-great-information.283508/ you missed the most important step. since you are bringing the boat to bare aluminum, you need a good etching compound like...
  2. Scott Danforth

    Sound deadening

    spray foam insulation is not fire resistant. marine sound deadening foam is.
  3. Scott Danforth

    Front Deck Rail Replacement on Four Winns Horizon

    depends on how fourwinns wired it.
  4. Scott Danforth

    1972 Glastron v164 trim gauge

    welcome aboard. the gauge and sender testing information are in the factory service manual. most likely the trim sender on the drive is bad, they only last a few years.
  5. Scott Danforth

    1988 Bayliner Capri with a 2.3L OMC Ford cobra

    so it works, it is just not accurate. your boat also is not sitting level. My guess is the sender is at the front of the tank. so replacing it wont change the accuracy unless you go with a custom programmed ultrasonic tank level sensor vs the resistor and float arm.
  6. Scott Danforth

    axle repair sleeve question

    If you have the correct speedi sleeve, you have to heat it to put it on, then it shrinks in place
  7. Scott Danforth

    Front Deck Rail Replacement on Four Winns Horizon

    Depends. Sometimes yes Usually screws and sealant
  8. Scott Danforth

    help with 1989 Celebrity Boat (5.7 Mercruiser)

    Fuel lasts 12 months from date of distillation max. What you have is varnish
  9. Scott Danforth

    2005 350 Mag dropping fuel pressure under load

    Have the injectors tested Test the fuel pump Test the anti siphon valve Check the contents of the fuel filter
  10. Scott Danforth

    2005 350 Mag dropping fuel pressure under load

    Bad injectors will cost you your motor. Have them tested
  11. Scott Danforth

    1988 four Winn horizon 200

    Any 1986 and later marinized SBC. You will have to make sure you have all the OMG bits. However I would look for a 1996 or newer Mercruiser/ alpha combo and replace everything pulley to prop after you make sure the hull isn't rotten
  12. Scott Danforth

    How tight? Leaf Spring Bolts.

    You tighten them to the sleeve The plastic bushing is what moves
  13. Scott Danforth

    1997 90 hp service manual

    eBay for used
  14. Scott Danforth

    Front Deck Rail Replacement on Four Winns Horizon

    Unfortunately most sub 26 foot boats are a assembled with only profit in mind. Not maintenance Pull rub rail Remove all the screws Remove cap. Without knowing specifics, that is all I have.
  15. Scott Danforth

    Front Deck Rail Replacement on Four Winns Horizon

    Rail stanchions either have a threaded stud with a nut and washer from below or a pad with screws from above On smaller boats, the whole cap and deck are usually rigged before the cap is glued n screwed in place. This includes hand rails. If you do not have access, you may have to cut access...
  16. Scott Danforth

    Volvo penta 2008 leaking water on left side of engine

    Freeze damaged. Look for cracks in the block
  17. Scott Danforth

    Front Deck Rail Replacement on Four Winns Horizon

    Most likely the rail was screwed on before the hull was decked. Find a replacement before you worry about how
  18. Scott Danforth

    In storage 13 years, oil turned to jelly

    Replace the impeller, bellows, etc.
  19. Scott Danforth

    1988 Bayliner Capri with a 2.3L OMC Ford cobra

    What trouble shooting steps have you done
  20. Scott Danforth

    Removing impeller

    This is an old thread. Please read the rules
View older results
Top